Getting too hot, thermal overheating, power or ground might have issues, short circuit or bad speaker impedance. All of those things could trigger protection mode on the amp. Ton of things it could be. Maybe speaker is wired for less than 2 ohms and amp can’t handle it.
Before I installed the DSP, I had replaced all of the factory speakers. Immediately, sounds of clipping at volume 20’ish. With the amp/DSP, clipping went away completely.
Thanks!
I took a look at the instructions and didn't see any info about the wiring for the lighting. I am sure its easy to connect but what is the route for the wiring?