Sponsored
Gluestick's latest activity
-
This. You would be surprised at how the slightest change of angle of a picture taken can change the dynamic of what the picture is... -
You can tell from the pictures alone that one is taken more to the right side of the vehicle.
-
Gluestick reacted to SierraBronco's post in the thread More travel, more clearance, and no gearboxes? with
Like.
Vasher has an awesome Bronco solution that’s reminiscent of the RCLT kits for the Toyota crowd. I hit him up for some details and you’re... -
Gluestick reacted to userdude's post in the thread Tired of the Sticker Blight on Trails?? with Like.
We have bullet holes round these parts.
-
Is it just me, or is anyone else starting to see stickers plastered all over signs, guard rails, fence posts, etc. as ugly blight and...
-
It's just a Warranty Approval message since there now two parties that warranty....
-
Gluestick replied to the thread Bora Wheel Spacers.They are often made rather than stocked so a delay may occur.
-
I have a 2022 Badlands Non Sasquatch. I ordered 1.5" Wheel Spacers from Bora back on July 11. I haven't seen a tracking number or...
-
Yes. Snug fit and no damage to the powder coating after 2-3 times latching it
-
Gluestick reacted to Q1svt's post in the thread Third Brake Light - using the Ford 7Pin plug ? for 2025-plus OEM module with Like.
Thanks @Gluestick ... I've read your posts on your build, and your use of the DT connector. My AAL Mass Storage is not going to be on...
-
Gluestick replied to the thread Garmin PowerSwitch.It should be really straight forward!
-
Just got my Blaze order yesterday. Bought the whole kit they have. I'm the dullest crayon in a box of crayons, so hopefully I don't F...
-
Gluestick replied to the thread Third Brake Light - using the Ford 7Pin plug ? for 2025-plus OEM module.You can cut the OEM third brake light wire and use Deutsch connectors to act as extensions to mount it wherever you like. I also got a...
-
The TN offroadeo is today. August 8th 26. You guys and ladies attending are in for a sloppy treat! We will do a Sunday run at windrock...
-
Gluestick replied to the thread Garmin PowerSwitch.You’ll get great support via @Blaze Off-Road
-
Okay, thanks! My main concern was reading the warning on Garmin's site to not connect this to a vehicle with a "smart charging system"...
-
Gluestick replied to the thread Garmin PowerSwitch.You plug into the OEM battery’s bus bar, just like where the Ford Performance winch goes — there are two unused threaded studs for just...
-
Gluestick replied to the thread Garmin PowerSwitch.I use the Garmin PowerSwitch. Connects to battery just fine. I’ve connected mine to a Genesis smart battery management busbar (dual...
-
Gluestick reacted to Glen24's post in the thread Let's talk lights. How much lighting needed? I need suggestions. with Love.
Never to much lite
-
Gluestick reacted to agentdarnell's post in the thread Let's talk lights. How much lighting needed? I need suggestions. with Like.
Anyone have any experience with the Harbor freight Roadshock 3" lights? They have both flood with side light and spot with side light...
-
Gluestick reacted to HotdogThud's post in the thread Let's talk lights. How much lighting needed? I need suggestions. with Like.
Like I've said before man, I think you've got too many lights, but I can't argue with how meticulous of a job you did, it's really quite...
-
Gluestick reacted to Ground_zero298's post in the thread Let's talk lights. How much lighting needed? I need suggestions. with Like.
I know what I needed for my activities. A half mile lit up circle for predator hunting and letting the dogs work. Guess it comes down...
-
Gluestick reacted to MarkInOhio's post in the thread Very Clean Midland MXT575 GMRS Radio Install with Mountains2Metal Bracket and 67 Designs Mic Mount with Like.
I finally got around to mounting the RJ45 connector. I tested it out first using a short ethernet cable I already had and it didn't...
-
So a base, absolutely no options FWD XL (100A) 2.0L EcoBoost is MSRP: $29,685. Same build but with the XL (101A) 2.5L Hybrid AWD goes up...
-
Gluestick replied to the thread Let's talk lights. How much lighting needed? I need suggestions..@NoloBronco has a similar setup re rear lights and euro fog switch and bumper harness too.
-
Gluestick replied to the thread Let's talk lights. How much lighting needed? I need suggestions..I am a huge fan of the Devos Lightranger 2000 and there are tackform mounts you can use off your roof rack. the back of my Bronco has...
-
-
Gluestick reacted to Q1svt's post in the thread Let's talk lights. How much lighting needed? I need suggestions. with Like.
… I use a Jackery for camp, but interested in what you’re using out back on the bronco?
-
Gluestick replied to the thread Let's talk lights. How much lighting needed? I need suggestions..I strongly feel (cue Iron Maiden - Fear of the Dark 🎶) that MOAR lights is better. Late night rural drives on windy roads being part of...
-
-
Gluestick reacted to Bellime's post in the thread Bigger intercooler + charge pipes worth it for 2.7L? with Like.
As far as intercoolers. If your going to upgrade your beast, this will be one of many so choose one of the great 3rd party...
-
Gluestick reacted to GA2Dr's post in the thread Bigger intercooler + charge pipes worth it for 2.7L? with Like.
Yes. There are options that bolt in with no mods, including cPE intercooler and CVF charge pipes, which is what I went with (also did...
-
Gluestick reacted to Brian_B's post in the thread Hardtop side panels — finally found something tool-free (Raptor) with Like.
Looks like another brand of them, but yeah, more or less https://www.rockworkx.com/collections/bronco-6g-hard-top-removal-bolts
-
Gluestick reacted to Mike's Bronco's post in the thread Hardtop side panels — finally found something tool-free (Raptor) with Like.
Were you thinking of these? https://www.ez4x4.com/products/quick-release-thumb-screw-kit-bronco
-
Gluestick reacted to Brian_B's post in the thread Hardtop side panels — finally found something tool-free (Raptor) with Like.
Wasn't there a company making anodized D-Ring and knurled top bolts? Rockworkx?
-
Gluestick reacted to jlockerwildtk's post in the thread Recall 26S55: 2021-2026 Bronco - Engine Compartment Wiring Harness Repair [July 23, 2026] -- 590,000k units affected with Like.
My guess is that Ford Tech's will inspect the wiring harness for damage, fix if needed and then use more durable split loom tubing on...
-
Gluestick reacted to Deadpool392's post in the thread Very Clean Midland MXT575 GMRS Radio Install with Mountains2Metal Bracket and 67 Designs Mic Mount with Like.
I used this Tackform mount for my handset...
-
Gluestick replied to the thread B-Pillar Braces recommendations?.I have had similar experiences with monumental improvements from the Goatfab b-brace. Rode in a friend’s Bronco without it the other day...
-
Gluestick reacted to Canyon Coolers's post in the thread B-Pillar Braces recommendations? with Like.
I have had creaking from the C Brace bolts loosening. Also dust in there can even do it. I did the GOAT B Brace and the Ford...
-
Gluestick reacted to Bronco214's post in the thread Looking for inspiration: LED integration in grille with Like.
I installed a Flat X 23“. In Switzerland, the regulation stipulates a maximum of 480 LUX at 25 meters with all lights on. Unfortunately...
-
Gluestick reacted to LeJerk's post in the thread Very Clean Midland MXT575 GMRS Radio Install with Mountains2Metal Bracket and 67 Designs Mic Mount with Like.
bigger antenna = more fars
-
Gluestick reacted to Neps's post in the thread Very Clean Midland MXT575 GMRS Radio Install with Mountains2Metal Bracket and 67 Designs Mic Mount with Like.
Track Form also offers several radio specific microphone mounts, I used this one and it's worked very well.
-
You bet I did! If you know, you know....Richard.
-
Gluestick reacted to geargeek's post in the thread Recall 26S55: 2021-2026 Bronco - Engine Compartment Wiring Harness Repair [July 23, 2026] -- 590,000k units affected with Like.
In the meantime...double-checked the gauge on my fire extinguisher.
-
Gluestick reacted to Ducati1098's post in the thread Recall 26S55: 2021-2026 Bronco - Engine Compartment Wiring Harness Repair [July 23, 2026] -- 590,000k units affected with Like.
This is no different than any other manufacturer. They’re required to release and notify recalls to customers before any repair would be...
-
Gluestick reacted to GI_Jo_Nathan's post in the thread Recall 26S55: 2021-2026 Bronco - Engine Compartment Wiring Harness Repair [July 23, 2026] -- 590,000k units affected with Like.
You mean this s*** show? I was pretty shocked when I got this open. Rerouted it yesterday while removing that beehive crap back there...
-
Gluestick reacted to Ducati1098's post in the thread Recall 26S55: 2021-2026 Bronco - Engine Compartment Wiring Harness Repair [July 23, 2026] -- 590,000k units affected with Like.
We will find out in a week or so hopefully
-
Gluestick reacted to Ducati1098's post in the thread Recall 26S55: 2021-2026 Bronco - Engine Compartment Wiring Harness Repair [July 23, 2026] -- 590,000k units affected with Like.
-
Gluestick replied to the thread Winch power wire covers.Raychem DR-25 or Techflex. Raychem is my preferred and is truly the top of the line (handles high heat, oil, gas etc and shrinks down...
-
Gluestick reacted to Felix808's post in the thread First coat of MAXL ONE (all-in-one waterless wash, polish, ceramic-style protective spray) on 60th Anniversary Bronco with Like.
Now that I actually looked up the product , it looks very similar to Topcoat F11 that I use on most my bikes & a certain car. Again...
-
Gluestick reacted to Lej512's post in the thread First coat of MAXL ONE (all-in-one waterless wash, polish, ceramic-style protective spray) on 60th Anniversary Bronco with Like.
It’s a lot of work for an old, fat guy but I got the first coat of MAXLONE applied. I really like their product.
-
https://www.khcoap.com/product/KHC-Bronco-6G-Body-Brace?srsltid=AfmBOoptbUCKsc6jlk6fmVL_8ZEW3hZ6MXMoayAUlIjHE7eEMwdDZAF6 Metal is pretty...
