Recent content by nd4spd569

who makes that molle panel you have the AC1 mounted on?

Used this idea this weekend. Changed at 40k miles. Was definitely dark and lots of metallic sludge on the oem magnet. Hopefully just part of breakin. I used 4 of the 3/8” rubber clamps. One I straightened and removed the rubber and then attached the second clamp on reversed inward. The length...

Update: All installed and back together. Relatively easy install. On the base tune, OMG!!!! sounds so much better with actual mid bass in front and can actually feel the bass from the sub with a couple notches up in the dash settings. Will need to tune it to make it better as the dash needs to...

I was told only a small one during Black Friday but maybe.

As an update it was shipped out a week after order and is supposed to arrive today! Whoo!

How long does it usually take from order to shipping? I ordered on Sunday and haven’t seen anything yet. Wasn’t sure if it is a made to order or just usual time frame and not being used to Amazon Prime. Trying to plan I should pre take apart my bronco to just drop this thing in between needing...

Thanks. I am sold. Waiting to see if there’s a Memorial Day discount! Hah. But yes it was higher on the priority as it was supposed to be a much cheaper upgrade than suspension but it’s turning out to be slightly cheaper.

Thanks for the reply. For the single coil sub I saw there’s two in the wiring diagram, do you just connect one pair to sub or connect the two positives into the sub and two negatives into sub? Looks like I am sold. Going to see if they have any sales in these upcoming holidays.

Thanks for the reply. I’ll look into the sub. Any thoughts on whether or not I should replace the kick panel speakers? Also, mobridge can run either single or dual coil subs right? Did you tune with a umik/rew?

TLDR - would the mobridge kit give me decent sound with my current replacement alpine S speakers and DS18 sub or is it really only worth it if I go the morel, hertz, JL etc route that everyone seems to use? I am one that has been disappointed with the stock B&O. Did some research on fb groups...

Did you resolve this?

I just got an unloaded set and connected the spade connectors to my speakers but what is the little black connector for that split off the spades?

Got my check about a week after it was delivered. I did delay sending it in a few weeks to make sure it didn’t have issues or didn’t like it.

I had to use the spacer and a metal washer. Apparently mine is raked pretty good 🙃

Biggest reason I got them was for the trade in. My lights don’t have that color issue. Also figured out my drl issue. Drl only is on when you’re out of park unlike oem. Figured that out pulling up to a storefront and saw the reflection 🤦🏻‍♂️