Recent content by NOVA Bronco

I just bought the TrailRax rack during the Black Friday sales. I plan on running a Starlink and some exterior lights on the rack. What is the best method to run wires from the roof into the interior of the vehicle without compromising the seals and causing leaks?

I just bought the TrailRax TRMR rack for Black Friday. Just curious, when you wired all your lights and antenna, how did you bring the wires back inside the truck?

Thanks everyone for the inputs, I ended up going with the TrailRax rack without the PaxRax. @TrailRax had some pretty good deals for the holiday, but the shipping costs are outrageous. Would be nice if they followed companies like @DV8offroad and @Turn Offroad and offered free shipping...

I am wanting to buy a roof rack while Black Friday sales are going on. I am torn between RCI and Trailrax roof racks. I am running the Turn Offroad aftermarket hardtop and already have there Molle panels over the rear windows. So not sure if I would get the PaxRaks if I went with the TrailRax...

Just curious, how are you mounting your antenna/dish?

Great setup. What are you using for the white vents in your rear windows? Are you still running this setup?

So when did you order and get your Bronco? I have been waiting for the email like others. I ordered Aug 21 and got my Bronco 08 Jan 22.

After some man handling I got the LCA skids installed. The install is not as easy as the video leads you to believe. Just glad I was able to get them on.

Finally was able to get everything installed. The passenger side was difficult but after the help from the forum and IAG customer support I figured it out. Once the skid plate was in position I used a jack to get it positioned right. Then I tightened all the bolts. I used a slim line T25 torx...

Just and FYI, the front lower control skid plates do not go on as easy as the video suggest either. Skid plate mounting holes do not line up with the factory bolts. I tried measuring it out and it looks like the mounting holes are off center by about an 1/8 of an inch. I have a Badlands with...

Thanks for the info. I’ll give it a go and let you know how it goes. Wish the install was as easy as the video led you to believe it was. That’s the frustrating part.

Having same issue. What bolt did you have to loosen? Would be great if @IAG Support would add this to the instructions.

Which harness is corroding?

I got a good laugh out of that. I've let the "magic electrical smoke" out a few times when working with electronics. Once the smoke is out you can't put it back! lol

Nice work, looks great. How did you blackout the Bronco emblem in the middle?