Both our Broncos got pulled over outside Amarillo a year back for no front plate. First time in my life! Just got warnings so maybe he just wanted to check them out... still not putting a front plate on.
Going all the way around, does it impact the the rubber sealing the bottom of the window to the tailgate? I may do this as well, but was worried it would raise the top above the tailgate.
So I have the TOR top and recently installed the TOR tailgate reinforcement. After putting on the top, I heard a lot of noise that I hadn't noticed before because the soft-top was a rattle trap. After putting on the tailgate reinforcement, 95% of the noises are gone. I think the great bulk of...
So here's the tech notes for the side cameras: "Tech followed pinpoint tests L and M and when tech removed all trim from both side mirrors to gain access to camera connector, found that pin 1 and 2 from IPMB still had voltage when both cameras were disconnected indicating the coaxial cable to...
Check with Todd probably. If it was an issue then it probably wouldn't latch. The freight carrier had dropped/hit mine right on one to the arms that attaches to the hinge. New one being sent today, then I could probably see about the gaps.
My spare tire is off as well, unfortunately so is my tailgate. Hit a snag installing the tire carrier. It actually is starting to resemble the Bronco DR... the possibilities. :ROFLMAO:
@604Bronco TOR can certainly chime in, but my thinking is the bump stops on the rear of the third light are probably unnecessary now that the tailgate isn't bearing any weight from the spare.
I didn't get to put on the TOR tire carrier today so hopefully tomorrow. Love the idea and the tire carrier bearing the weight of the tailgate vs the other way around.