Search results

I need one

Okay if the library is doing it, that makes more sense. It may actually be cheaper for you to purchase a set already made then. Pla is a decent filament but it's not really rated for long-term heat exposure like what would be found in a vehicle. I would recommend ASA filament for its uv...

Your filament must be really expensive. A 2.2 lb roll on Amazon is usually around $20 and 704g needed for all six pieces is only 1.55 lb. Technically you should have some left over

Are there any sites or videos showing power increase on the dual injection 2.3 engines?

I bet I could make something like that work

So how does this work? Mine was made 10/25 so do I just wait for a notification from Ford or do I wait for an issue that may never come?

I might try to mount it where you have your battery disconnect but the fuse box is kind of big. It might have to go sodeways. I don't really want to mount on top of the factory fuse box. The included brackets are not really for the Bronco.

Going with an aftermarket auxiliary controller and looking for the best place to mount it under the hood. Pictures would be great

These are the skid plates I went with. For the price it's well worth the piece of mind that All the spinny bits underneath will be protected. https://www.extremeterrain.com/productphotos?webid=jks-bronco-front-lower-control-arm-skid-plates-jks8301&showFeed=True&customerpics=true&index=0 I should...

A couple weeks ago I finally got around to taking the entire top of and getting my Temu rear speaker pods installed with some Sony ES series 6.5's No pictures of the pods yet but they are identical to the Mabett option. Also got my Temu armrest cover. It fits pretty good for Chinese plastic! It...

Brand new tires this time. 285/70/r17. I got a great deal at $800 installed for the set. Still need to get the spare done but they had to order it. Anyone got an extra TPMS sensor?

I did the cargo area and the bottom of the cooler in the rear floor. I also did in the passenger side around the factory sub. Going to be pulling the enclosure back out to do a little bit more since it rattles still and going to be completely doing the back of all the rear plastic panels since...

What is going on with their dyno sheet? 184hp and 189tq? Those numbers are way off. Maybe they meant bronco sport. No way we lose 116hp and 136tq to the wheels.

Got some new rubber and started my wireless aux switch install

I can't remember if I replied here already or not but I'd like to throw up a lesser known brand. Xforce makes a valved exhaust that is electronically controlled so the driver can select how loud they want it. https://xforceusa.com/products/ford-bronco-varex-valved-catback-exhaust-system .There...

I would put a level up to each wheel and see how far off they are

Yeah that's the one. Don't really want to pay another 70-90 bucks since I already have this paperweight.

I unfortunately ordered the wrong switch and my local Ford parts center won't take it back so now I am looking for the correct switch. Don't need rear fogs or even mirror lights. Just front fogs

I would test drive a manual and look at other trims. I kind of rushed mine because it was one of two on the lot at the discounted rate. I wound up with a shadow black base but they had a big bend that was either marsh grey or that really pale blue.

There's almost nothing available for 2025+ 2.3 yet. Burger has a intake that supposedly works but with the redesigned engine, vendors are still developing everything. I think as of right now there's only 2 tunes available and nothing in the way of charge pipes, downpipe, tb spacer, etc. It sucks...