Search results

EBB stands for Electronic Brake Boost as opposed to vacuum assist brake boost. This caused lots of problems for us with the 2..7 V6. There are lots of threads about this. I have a 2021 OBX 2.7 V6 that I tow, I do not remove the fuses.

I assume you have a 2.3L I-4 the 2.7L V-6 as been EBB since day one.

The brake lights are disabled when you put the Bronco in Neutral Tow Mode.

With the "Software fix" that Ford put out serval years ago the brake boost goes to sleep as soon as you go into neutral tow mode. That's why you get the warnings when you go into and out of neutral tow mode.

I keep the key fob in my pocket while I'm doing the hook up. That way if I walk away with the ignition on the horn will honk a couple of times. Only did it one time way back in the begining.

I towed ours serval times before i putting the LOD brackets on . In fact the LOD brackets were not around when the 6G Bronco's first came out. Be sure the safety cables are attached to the frame not to the brackets!!

On my 2021 OBX 2.7 the Bronco brake lights are disabled with I put into Tow mode and there is not a electrical connection between the brake/turn signal lamps like in the old days. After you put your Bronco in Tow Mode press on the brake pedal and see if the brake lights come on.

I take a two pictures one of the dash and one of the GOAT mode dial once the Bronco is in tow mode.

It appears the 2024 2.3L still has vacuum boost brakes, so it should be the same as any other vacuum boost vehicle has far as flat towing. Just following the instructions in the manual.

Electronic Brake Booster. The power brake system is electronic assist not vacuum assist.

By keeping the Fob in your pocket when you leave the Bronco, your will get a friendly couple of honks if you left it in accessory mode when you close the door. Just saying!! I then keep the fobs in the motorhome. Tilzbow I definitely agree keeping the brake peddle well pressed until the...

The brake lights are disabled when you put bronco into Neutral Tow Mode.

There is a know anomaly that has happen to my 2021 a few times and to other's that have reported it in this forum. The Electronic Brake Boost will become active, causing the Bronco brakes to lock up when the axillary brake system calls for braking assistance. The original brake system software...

Yes that is road curd you are smelling. Turn your Heater/AC off as part of your tow mode setup. Then do not turn is back on until you put about 20 minutes of heat time back in the engine.

Good idea to listen for the shift in neutral.

Been doing a little digging this evening. Looked at a couple of videos of replacing the clutch pack in the 4A transfer case but they when no farther. One video showed how the motor engages the clutch pack. Did read there is a planetary gear set for four wheel low but do not know how it is...

On my 2021 OBX the brake lights are disabled when in TOW MODE. The brake light relay was for back in the day when the brake lights were controlled by aswitch on the brake pedal and hard wired through the turn signal switch. Now the brake signal goes to the computer then to the brake lights.

I put a notes on two Motorhome forums along with your email address. About what you are looking for and that we are not lawyers.

They updated the HTML online manual but not the pdf manual. That was the original fix before they came up with the software fix. Sounds like they are saying the software fix is not working, should be something there we could use to fight the warranty claims. Update: Just remembered the fuse...

I would like to know how many emails you get from owners with transmission failures while towing. THANKS!