Search results

Figure its a long shot with how ancient this thread is, but are you still trying to sell these?

@broox have you been happy with the performance of the antenna there?

Good deal. Happy with them so far?

Hate to steal SATXBD's post, but seeing as its July now I hope they won't mind, do you have a 4 dr set you're keen on selling?

Wife took the kids up to Colorado much earlier for the 4th of July than my PTO would bear, so when left to my own to make my way there for the weekend, I used it as the perfect rationalization to duck out of work at 3pm and putter my way up there. Much like the drive, 75% of it was getting out...

Bumping this one back to the top, mine somehow backed its way out and is probably hanging out somewhere with my 10mm socket. Didn't realize it until I was chasing a new rattle from the back and found the pod hanging off the top bolt.

Not sure that I agree that it's small as a whole, but I'm 100% with you on the wheel selection. There are quite a few reasonably priced, lighter aftermarket wheel options out there, but precious few of them come anywhere close to the factory offset. I have no desire to push my tires outboard...

Well it's not the soft, beautiful turf of Arkansas (I'll make it there someday soon @kodiakisland ), but I did manage to get permission to land at a grass+dirt field on the Llano river in the hill country. Fun experience, with the exception of picking sticker burrs out of absolutely everything...

Where is this at? I need more grass strips (and reasons to get away during the weekends) in my life.

Celebrated the checkride with a run down to LBX with my son for some seafood

Finally got off my ass and knocked out my CFI checkride. Huge relief to have that done with.

Well, I went and made an emotionally awesome (and financially terrible) decision:

Very disappointing to see. The AT3w was a compelling K02 alternative as they were except for their weight, and these are almost 6 lbs heavier!

The good news is I have discovered that the Bosch 17OEs have the right adapter to fit the pinch tab interface. The bad news is they have an even shorter lifespan on the Bronco's flat windshield than the OE ford wipers before they start skipping across, and they cost too damn much for that. The...

This is fantastic, definitely watching this thread for future progress!

I have not seen anything to contradict this, 80W-90 up front and 75W-85 in the rear if buying Ford lubricants.

How are they noise-wise versus the stock GYs?

Man it sure took them long enough

The sensors are the same between the two bumpers, but the grommets are different. The part numbers for the grommets have been posted in this very thread, please have a read through it.

Man that's a stout lead time for a freakin tire! Hope they keep the C-load 35" and 37" sizes going with the K03.