Search results

Yep. Sometimes I have to hold it down until the motor turns off and do that several times before it finally works. Its really fun in the winter going over the mountain pass. :rolleyes:

Memory seats, rear AC vents

Yes. Especially if it is warm out.

Intech Flyer Explore

If it doesn't work, there's a homemade DIY here: https://www.bronco6g.com/forum/threads/diy-factory-tow-package-using-oem-parts-with-forscan-as-built-data-without-error-codes.49906/ I added it to my Badlands following that thread.

Bronco did great. Pulled really well. This TT is about perfect size for the Bronco (2000ish lbs). 400 miles through Colorado mountains on I70. Did 65 mostly but had it up to low 70s a few times no problem.

First tow. Worked like a charm.

https://www.bronco6g.com/forum/threads/tow-package-arrived-contents-inside.17659/post-1960258 This would appear to make things a bit easier.

https://www.ford.com/cmslibs/content/dam/brand_ford/en_us/brand/resources/general/pdf/guides/21Towing_Ford_Bronco_r2_Jun24.pdf Tow rating will not change by adding the wiring.

I would think if you can order it as an option, you can add it later. But I could be wrong.

If you want to get rid of the extra speaker I will buy it off you.

Then rear pods, sub, and kick panels last?

If you had to do it in stages, where would you start?

I did it so you don't have to... 😂 When I was trying to disconnect C201 and C105, I was sure I was going to break a tab, so I went ham and took the fender off. Thanks to @RoverDude first for the excellent write-up, and @PDEvans for the follow-up information and answered questions. This post is...

Am I dumb? I'm trying to get the wheel well splash guard clips off and the screws aren't moving out (I'm keeping the base stationary with my finger).

Thank you! I found some on Ebay, but if those don't work out for some reason I'll definitely hit you up!

Nevermind. There's a 2000 minimum for that one.

13627267-L are on backorder. They are here: https://www.mouser.com/ProductDetail/829-13627267-L Any reason why I couldn't use this sealed terminal instead: https://www.mouser.com/ProductDetail/?qs=IN21uv1u6AmmEiXWKkSjPw%3D%3D

As for this part in relation to the 7 pin pigtail: Using a depinning tool remove the front cover. De-pin (1) existing terminal, carefully prying and removing existing boot seal. Reuse the old boot seal on the new wire(s) you ran; strip and crimp to the correct size terminal. (White wire /...

Thank you for this... been trying to figure out how the colors correspond myself.