hey @Deebocubs, wondering if you experimented at all with the different wraparound windjammer options as there are several different models for different jeep models. Wondering which one fits best!
Has anyone installed the warn elite rear bumper on a non-sas bronco and have pics? I love the bumper and the price, but I'm concerned that the bumper ends might extend farther than the non-sas flares which are narrower.
Finally got around to installing my platinum bimini top -- it's awesome! thank you @JTopsUSA for making such a quality product.
I do have a product "add on" suggestion. I think it would be great if there was some sort of temporary rain/solid cover that integrated with the mesh top. I mean...
Yes, I have the headliner -- here is a photo of one of the cap nuts. super clean, they are hard to see as they are effectively over the rollbar. The earlier photos show track placement.
Hope this helps!
Will try to snap a couple later today, but for now I can tell you that nobody has noticed they are even there. The shop did a nice job and had really cool black cap nuts that look factory.
Also -- 1 tip, buy an extra set of landing pads and install two sets on the rear cap, one pair on the middle piece. That way if you want to run in the summer with both racks on the rear cap and front / mid roof panels removed, you can!
I had them installed professionally, but it's essentially this kit EXCEPT my bars are 60". These 54" bars I believe will work, you will just have less overhang on each side.
https://yakima.com/products/54-sl-hard-top-kit?_ga=2.33923879.704348489.1673900516-761504259.1673900516
Has anyone done a partial xpel stealth (or similar satin) finish on an EG Bronco? I saw a Defender the other day where the vehicle had in essence a "matte design" wrap....hood was two tone matte / glossy, fenders were matte, doors were two tone, etc., and it look really cool.
I wanted the same solution as the OP, and had my local rack shop (RackNRoad, San Rafael, CA) install Yakima tracks on my rear cap and my middle MIC section. I have a ton of flexibility this way , able to adjust rack location back and forth, plus don't need to remove in order to remove roof...
I swapped out the supplied pins for quick release pins I found at West Marine -- and it reduced the pin chatter by 90%
https://www.westmarine.com/west-marine-quick-release-pin-3-8inch-dia.-x-1inch-usable-
West Marine Quick Release Pins
I'm currently in process having a bracket fabricated that would secure the back of the front panels OR the mid panel (I have a 4 door). Will post when it is finished.