So I been looking around for a solid response to this. I have not found any , if anyone has , please link the post in the reply.
Ok so maybe 10 or so times over the last year I've had this message pop up about the parking brake. Now , I just push the start button and everyone resumes...
As my bronco has several things themed around helping me haul gear down to the OBX for fishing for Redfish and using it for Redfish Fishing =) I give you some custom decals
So this interior was professionally done by me , inside you barely see any wiring , I utilized the JCR T Molle cage I installed for this. There is an extensive post I did on this on all the parts I used. I'll post a link to that post. Essentially all the items for this in an amazon cart might...
I recently installed one on my 2022 Bronco. Ran the hot to the same hot for the Oracle letter lighting. Grounded to the battery. I hooked the left and right turn signal wires to the wires behind the plug that attaches to the headlight housing just like a lot of others have done.
Now on to the...
Seeing the differences. As it turns out , my harness is probably longer than factory which increases resistance and lowers wattage output and amperage. I can shorten it a few feet and will do so when I move to a Bussman waterproof fuse panel.
Comparison of Harness
Real world time for when I go to the beach to get an idea of how long each process takes versus what I have seen in the past.
Real World Deflate/Inflate
Ok series of photos to show my lights after adjustment this is low beam factory
Next shot is spots upper without low beam
Next shot is spots upper in wide angle view
Next shot is spot view of the bronco
Next shot is floods lower view of bronco
Last shot is flood lower wide angle view
Thanks...
First I test the lights to see the draw of amps. in the first 4 pictures you can see the load of the rough county light and the auxbeam as singles. Now I know what I'm dealing with I can use the best Fuse and size wire for the task. ALWAYS over size your wire some and keep you fuses just over...
Ok this is going to be long and a few pictures. I'll be as detailed and hyperlink friendly as possible. This first pic is just a frontal view at mid ground level. Overall look not complete , I still have to run wire from all the lights in the bumper and the bull bar lights that have to be...
Keep in mind the adhesive tape on the inside will be removed and the letters will be attached with epoxy so that the light coming through does not show dark spots. I have Bronco in NC Blue is One , OBX NC in Blue Red Blue is Two , and OBX NC in White Red Blue is Three. Which do you prefer? I'm...