Search results

Yup, those are the ones that I have.

Here's the batteries I have been using with my Milwaukie tools and I assume this would work with the air compressor: Milwaukee 48-11-1852 M18 REDLITHIUM XC 5 Ah Lithium-Ion Extended Capacity Battery (2-Pack)

The unit uses Milwaukie's M18 battery, the same battery that's used on their power tools, portable vaccum, etc.

Thanks so much! Worst case scenario, I could pack two M18 batteries and that looks like it would cover most normal air down/air up scenarios.

Specifically, would this be able to pump all four Bronco tires from a psi of 10-15 psi up to the factory spec 39 psi on a single M18 battery charge? Thanks!

Yup that's what I wound up doing; they found one that fit the thread size and the diameter of the ball mount perfectly. It's been working like a charm.

Very cool, thank you! Do you happen to have any videos of trips that are fairly close to the Portland metro area? Tillamook Forest, coastal trips etc?

I put on a rubber washer under the dash ball mount, removed the GoPro mount (extra weight) and just have the arm and Magsafe mount (as you do in your picture). Seems to be holding tight now.

Thanks again for this guide; I ordered all the parts and the setup works great! One question: Do you have an issue with the base loosening and rotating/swinging over time? If so, did you do anything to secure the base? I posted in another thread and folks have recommended using Loc Tite or a...

One other question: Is the lock nut a specific type of nut or is just any nut that fits over the thread of the "male" screw that twists into the accesssory mounting point?

Thank you!

Thank you!

Thanks! Is this just a rubber washer?

Thanks to another poster, I assembled a phone/GoPro magsafe mount that attaches to the upper dash accessory mounting point. Works great except that over time because of the eight when the phone is attached, he base mounting point becomes loose and the whole assembly sways, sometimes tossing the...

Nice work! I am definitely not interested in sacrificing any cargo room.

Yes, I think it was the Fusion, thanks!

True!

I had a 2019 Bullitt with the B&O system. It sounded great to my ears but like I said I am not really an audiophile. Yeah, ideally someone out there just has the original parts and would be willing to sell them to me as a plug and play. Not really interested in relocating amps, subwoofers...

Thanks for the replies thus far! Totally get that aftermarket parts would yield much better results but I am interested in getting the car to the point as if it came from the factory with the stock/OEM components, even if it yields a lesser improvement in audio quality.

Hope everyone's well. Question: I have a 2023 four door Heritage Edition that had the subwoofer delete due to parts constraints issues. Can anyone post a video or direct me to a how to essentially make the car as though it came with the stock Ford OEM subwoofer? Searching this forum and the...