AGS OFF-ROAD joins Bronco6G with their first Bronco product! Tailgate Pass-Through

[AGSOFFROAD]

Introducing the BRONCO Tailgate Pass-through!

The Tailgate Pass-Through for BRONCO is a cheap, easy, and clean way to wire your license plate relocation brackets, reverse lights, radio/cell booster antenna, and so much more. By utilizing the factory cab pressure reliefs, this is a no-drill, no-cut installation. The front bracket features three pre-tapped holes in two different sizes to accept two small and one large cord grip. This kit comes with three Cord Grips and the corresponding plugs if not in use. The included gaskets and O-rings keep water and debris on the outside of your vehicle. Lets leave the messy mod installations to the jeep owners!

Features

Made from Aluminum

Zinc/stainless hardware

(1) 1/2 NPT cord grip 0.39"-0.55"

(2) M16 cord grip 0.18"-0.39"

(1) 1/2 NPT plug

(2) M16 plug

100% made in the USA

Use promo code "bronco6g" for 10% off your order. https://agsoffroad.com/products/2021-bronco-tailgate-pass-through

Sponsored

 

[Ironiguana]

Introducing the BRONCO Tailgate Pass-through!

The Tailgate Pass-Through for BRONCO is a cheap, easy, and clean way to wire your license plate relocation brackets, reverse lights, radio/cell booster antenna, and so much more. By utilizing the factory cab pressure reliefs, this is a no-drill, no-cut installation. The front bracket features three pre-tapped holes in two different sizes to accept two small and one large cord grip. This kit comes with three Cord Grips and the corresponding plugs if not in use. The included gaskets and O-rings keep water and debris on the outside of your vehicle. Lets leave the messy mod installations to the jeep owners!

Features

Made from Aluminum

Zinc/stainless hardware

(1) 1/2 NPT cord grip 0.39"-0.55"

(2) M16 cord grip 0.18"-0.39"

(1) 1/2 NPT plug

(2) M16 plug

100% made in the USA

Use promo code "bronco6g" for 10% off your order. https://agsoffroad.com/products/2021-bronco-tailgate-pass-through

Can you back the camera up a bit? Struggling to picture where this is at on the tailgate. Thanks

 

[AGSOFFROAD]

Absolutely! In this photo the wires are tucked into the factory harness hole and the tire carrier is removed so the product is visible.

 

[R.A.N.M.J.]

Absolutely! In this photo the wires are tucked into the factory harness hole and the tire carrier is removed so the product is visible.

Does this have to be installed in the bottom left of the lower panel? Or, is it able to be installed in the top left of the lower panel or the bottom left of the upper panel? Asking mostly out of curiosity.

 

[AGSOFFROAD]

It can be installed on either relief panel and doesn’t not matter if it’s on the top or bottom. As long as it’s on the left side it will work as intended.

 

[Beach_Bum]

Absolutely! In this photo the wires are tucked into the factory harness hole and the tire carrier is removed so the product is visible.

So can you explain the purpose of your Tailgate Pass-through. You are showing the wires/harness that come out of the OEM "Pass-through" only to be directed back to your pass-through. The close-up pictures first posted made me believe that your pass-through would eliminate the OEM pass-through for a cleaner integrated design.

Sponsored