Go Rhino RB30’s installed

[Loganbachson]

Hadn’t seen anyone order the new series of running boards from go rhino yet. Everyone has the rb20’s or some other variation. I went out on a limb and bought the rb30’s. Love the look of them. They’re rock solid and it’s just enough of a drop to make it easier getting in and out without dragging my butt on the sides of the bucket seats.

Sponsored

 

[BBoyM3]

Thanks for posting. I didn't know these existed. I ordered RB20s yesterday, but I think I'm going to change my order to these.

 

[Loganbachson]

Thanks for posting. I didn't know these existed. I ordered RB20s yesterday, but I think I'm going to change my order to these.

I chose them mainly to get a little more coverage behind the front wheel. Don’t like the look of mud flaps.

 

[Smitty1979]

Hadn’t seen anyone order the new series of running boards from go rhino yet. Everyone has the rb20’s or some other variation. I went out on a limb and bought the rb30’s. Love the look of them. They’re rock solid and it’s just enough of a drop to make it easier getting in and out without dragging my butt on the sides of the bucket seats.

Do your steps pitch down in the back? I have the rb20's and love everything but the fact they pitch down looks absolutely terrible. I sent Go Rhino pictures a week ago and heard nothing. This picture shows the drop very noticeably.

 

[Loganbachson]

Do your steps pitch down in the back? I have the rb20's and love everything but the fact they pitch down looks absolutely terrible. I sent Go Rhino pictures a week ago and heard nothing. This picture shows the drop very noticeably.

I notice a slight pitch down towards the rear. Figured it was them designing them for the rake it has from the factory. Seemed like an odd design choice.

 

[BBoyM3]

I'm getting the RB30s installed tomorrow. I'll check mine once installed.

 

[NurseDan]

I went with RB20s but RB30s look great too. I picked the GoRhinos hoping that'd fit my 2DR with factory mudflaps, without having to modify anything. Luckily, fit great with no mods to mounting or the flaps to fit!

 

[T.S.]

Hadn’t seen anyone order the new series of running boards from go rhino yet. Everyone has the rb20’s or some other variation. I went out on a limb and bought the rb30’s. Love the look of them. They’re rock solid and it’s just enough of a drop to make it easier getting in and out without dragging my butt on the sides of the bucket seats.

How difficult was the install? how long did it take?

 

[thatch11b]

Do your steps pitch down in the back? I have the rb20's and love everything but the fact they pitch down looks absolutely terrible. I sent Go Rhino pictures a week ago and heard nothing. This picture shows the drop very noticeably.

I have the same and I thought I was going crazy about the slight slope towards the rear( Hard to see in this pic.)

 

[Smitty1979]

I have the same and I thought I was going crazy about the slight slope towards the rear( Hard to see in this pic.)

I contacted Go Rhino and they stated they are only supposed to taper width wider front than the back in regards to the step. The woman I spoke to said since I purchased December 2021 they "had issues " with warped boards but I indicated the brackets and or design lools like shit. So I may be getting boards then brackets or both. But they must be a shitty design as most everyone's look like this. Good coverage, good quality the astetics are terrible.

 

[thatch11b]

Good to know. I also have been thinking about changing them out

 

[Loganbachson]

I agree that it’s a bit off putting seeing the gap. But I’ve yet to have anyone notice but myself. Loving the coverage too much to change them to anything else (and i really dislike the stock ones now that I have these).

 

[Loganbachson]

How difficult was the install? how long did it take?

First side took longer. But got in a rhythm and finished it in about just over an hour.

 

[BBoyM3]

I'm getting the RB30s installed tomorrow. I'll check mine once installed.

I had them installed at 4WP today. Yes, they slope front to back, and it’s noticeable. I took pictures and sent an email to GoRhino customer service. Waiting for response. I'm still waiting for thier R&D to get back in tough with me. It appers to be an issue with both recent RB20s and the RB30s. I will update once there is a resolution to the issue.

 

[BBoyM3]

I contacted Go Rhino and they stated they are only supposed to taper width wider front than the back in regards to the step. The woman I spoke to said since I purchased December 2021 they "had issues " with warped boards but I indicated the brackets and or design lools like shit. So I may be getting boards then brackets or both. But they must be a shitty design as most everyone's look like this. Good coverage, good quality the astetics are terrible.

Any update from Go Rhino? I'm still waiting a response regarding the same issue with RB30s.

Sponsored