New billet aluminum parts

[switch311]

Hey Guys

Long time car forum member but more from BMW and Lotus over the years.

Broncos have long been in my family though so I had to get one when they launched them. 2 years later it has finally touched down!

I own a manufacturing company that produces aluminum parts for the Marijuana industry so I am putting the tools I have to work on random Bronco parts Id like to add. Some are already being milled right now so I will be putting up photos of each part as I get them finished. If you guys would like to get a group buy going for any parts you like that I make then we can get that done!

Here are a few photos of the Bronco its Eruption Green 2 door base model with a manual trans and sasquatch

Sponsored

 

[GravyTrain]

I’m in!! The grab handles on either end of the dash need to be billet!

 

[switch311]

That can be done! Currently getting a set of grab handles being milled out of 6061 to reach for up top so I'll make matching set to replace the dash grab handles with too.

 

[GravyTrain]

So glad you are doing this! Super excited your here.

Sponsored