Show me your 3D printed accessories. 3D Prints for Bronco Enthusiasts.

[KillerPenz]

Only thing that might throw off the calculation would be supports if necessary (not sure if factored into your count or not).

I managed to lay out the parts that the only thing that needed any extra support during printing was the lower pocket. All the rest were able to be printed in place without any help

To be honest I just slapped it into Bambu Studio and sliced all plates. Normally I would mess around and flip objects if it's beneficial. So the 450g it returned seemed like a pretty good baseline.

In the past I looked into adding color to the name & logo, but that returned quite a bit of waste.

Sponsored

 

[beachbraptor]

Finally had a chance to test my roof clips for my awning setup. Worked great.

 

[PowerBronco]

Created the steering rack bushings for the Hoss 2.0 rack. I am going to be working on these to see if I can design them in a way to be able to slide these in without having to take the tie rod ends off.

 

[swooshdave]

Created the steering rack bushings for the Hoss 2.0 rack. I am going to be working on these to see if I can design them in a way to be able to slide these in without having to take the tie rod ends off.

What are you planning on printed them out of?

 

[PowerBronco]

What are you planning on printed them out of?

Probably one of these types of filament - nylon, polycarbonate, nylon blend or polycarbonate blend. I'll have to see what works best.

 

[Squatch]

Probably one of these types of filament - nylon, polycarbonate, nylon blend or polycarbonate blend. I'll have to see what works best.

Do you have the ability to print POM?

 

[PowerBronco]

Do you have the ability to print POM?

I've never printed with POM, but my current printers are capable based on the required temps, ECT.

Sponsored