Search results

Here's the full view of the back.

Here's some pictures utilizing the stock camera housing that was cut off the standard tire mount. I also used a DV8 license plate bracket. The DV8 license plate bracket did require me to use a cutting disc to cut into the tailgate bracket so the DB8 plate frame could be slid into position.

If you want to save a little money, you can use the original camera mount. I used a scroll saw to cut the mount off the factory mount, leaving the lug holes. I extended the wire on the outside of the tailgate.

I'm just installing my LOD bumper. There are adjustments that need to be made during install. You can download the instructions with the link below. https://lodoffroad.com/products/bronco-destroyer-rear-bumper-w-tire-carrier/bbc2100

Has anyone installed or can confirm that Eibach E86-35-056-05-22 is a 2.0 shock with the new heavy duty springs?

I called Eibach last week and was told that the HD springs might be out at the end of July.

If you can borrow from your 401k, that might be a win win. Pay yourself a higher rate than the current stock market.

I wrapped my hood and A pillars matte black to prevent glare and rock chip protection.

Not OCD, I just want it to look clean after washing. Not OCD. I just want it to look clean after I wash it.

I purchased hinge covers online, so after market. The covers were a gloss plastic and didn't look good with the contrasting black. After using the Peel Coat, they look like the were made with the fenders.

I found that it's almost impossible to clean the fender flares on the bronco. Spots from mud and dirt just seem to stay. Other items I've purchased have not matched or been a high gloss where everything else is a matte finish. I opted to go with some Rust-Oleum Peel Coat Matte black or the...

What doesn't work? Balancing beads have worked on me motorcycle for 20,000 miles.

I was just going to ask about balancing beads. I run them in my motorcycle with no problems. https://counteractbalancing.com/products/off-road/ https://counteractbalancing.com/applications/

Below is a response that I received from RCI about the difference in skids. "The plastic bumper sits higher than the modular bumper, so the skid plate for the plastic bumper extends upwards more to fill the space below the bumper. I would recommend going with the skid that will fit your stock...

The cup holder wouldn't fit with my floor mats. I didn't want to send the cup holders back, as they've been the best I've seen. I also didn't want to cut up my floor mat, so I pulled the rear mat out and heated up the offending area with a heat gun. Smashed the area flat with a block of wood...

I just installed my table tonight. Very pleased! Only issue was that the M6 screws that come with the kit are two different lengths and the instructions don't specify locations. There are 4 short and 6 long screws. I believe the six longer screws should be used on the lower mounting points and...

It's wrapped completely, so there's no exposed paint on top or around the edges of the hood or the window frame. I had it professionally done. Hopefully the hood and frame will be protected from Rock chips. I had the two front roof panels removed as well as the mirrors taken off, so they could...

Hood and around windshield.

I had my hood and around the windshield wrapped in matte black.

I just received these ones tonight. https://www.amazon.com/JWWY-Bronco-Compatible-Ford-Accessories/dp/B0B8HRCM1P/ref=mp_s_a_1_17?keywords=bronco+grab+handles&qid=1675555012&sr=8-17 They're one of the few metal handles sets for front and rear seats. They come with pads as well. Still...