Search results

Looks like they have more options now. I got the medium length arm (199mm 7.8”). Here is one of their new options. https://www.67d.com/products/arm-builder-pro-series-arms?variant=43943283097854

Anticipation is killing me! Hope they release soon!

Glad to hear that you got it working well for you. The 67 Design arm and Mag Mic are awesome and work very well. I've had my rig on many off-road trips with everything in the car bouncing around but, no rattle from the radio mount and the Mag Mic stays solidly in place!

No, by installing this way, I did not have to notch anything.

Thank you! Glad it worked well for you!

Sorry to hear about this. I tried to reach out as well after your last post and got nothing back. Thankfully, none of my decals have peeled off or had problems (yet). Let me know if you find another source for the decals for when mine might peel off.

Can’t wait! Scheduled for next week!

From 67 Designs, I'm using the "Arm Builder for 20mm - 20mm Ball Sizes - Medium / Matte / Black"

Sorry to hear you had a defective decal. I didn’t need to contact them (other than placing the order through the website) so not sure how to get ahold of them. Hopefully they reply to your emails.

Actually, just to the left of the grommet for the clutch is the main harness that goes through the firewall. At the top of that grommet is another hole in the grommet for you to pass your own wires through. You can get the antenna wire and a couple others through it.

I have the 275 in my Jeep and the 575 mounted in my Bronco. Both units use the same handset. The handset uses a RJ45 connector so you can do a remote install and run a CAT6 extension cable to have the Mic located somewhere else. The Mountain2Metal radio bracket makes it very easy to install...

I programmed the MTX575 so that both the Mic speaker and speaker in the radio are enabled. This provides plenty of volume to hear conversations over the radio. I also have the Mic mounted high on the top of the dash which I'm sure helps as well. I'd thought about adding an external speaker...

Great suggestion! Thank you! That would have been a much better way to go then using a drill bit as I did. Looks much nicer and sealed up. Will have to go find a set of the leather punch tools.

Hi Dave! I've been very happy with this install and have had no issues with the radio or things coming loose. I've owned several Midland radios over the years and they've always been very solid performers. I've been on numerous trail rides with this setup (some pretty rough) and been very...

I’ve also received the hood ajar warning several times since picking up my Bronco. Haven’t had the alarm go off though. For me it has only happened while driving off road though. Figured something to do with the rough terrain. Pretty annoying to have beeping at you while trying to navigate a...

I didn't like the way the grill letters and emblems were hard to see and didn't 'pop' out. Ordered the vinyl lettering and emblem kit from Vinyl Sometimes and installed. Getting the vinyl installed and placed just right did try my patience a little but, in the end it worked out very well and...

Just got registered for July as well. Can’t wait!

Looks awesome! Nice and clean!

I’ve had great performance with my MXTA25 mounted on the cowl. I’ve been on several trail runs with groups where we are spread out over several miles and had good RX and TX performance.

That is correct but, I actually used a 7/8" bit and then filed it until it fit perfectly.