So it would be like putting 5.73 on the rear?
Yeah you an anomaly 🤣
Mine is off, about four at slow speeds and up to about 6 at 80. So I just always figure 6
So question for all you smart guys out there. With the portals in the equation. What does the final drive be considered? Right now I have 4.7 in the rear and I know the portals do the gearing at the tires but what would be the equivalent rear to what we end up with at the tire?
Just curious!
Yeah thanks for the reminder, that is one of my concerns about the rotors I actually want to get a backup set just to have them that way you don't have to search for him when you need them.
You might I was very impressed how the RCI bash plate lapped right over and basically was perfectly flush with the belly skids It was like it was meant to be
I thought the same as you about cutting but you'd have to cut the belly skid and it's a mounting point and I really don't want to give up that structural integrity on the belly skid either so I think sandwiching is better. In regards to the hidden nuts I would probably tack them in place with a...
installed the NVR belly skids. Another instructions not that great but there product is amazing!!! Super strong feels almost bulletproof now!!!
Ford Bronco 74Weld Bronco Portals now available! 1000015408
Replaced my bash plate with the RCI one. It is 1/4" thick compared to 1/8" thick and had...
So I put them in place on both sides and I think I can get them to work but you would need a spacer plate under the one bracket per side and you would need to elongated the holes in the sides to receive the side bolts and figure away to hold the nuts on the inside of the frame because onelce the...
Evening all, been traveling a bunch.
Finally got the Turn Off Road tail gate and adjustable tire carrier installed!!
Really nice product. Instructions meh...
Feel better with the forty on the back now.
Also installed the NVR belly skids. Another instructions not that great but there product...
Just got back from FL running with T.O.R.R.
with the Braptor, had a blast.
Leaving this weekend for builder convention will be gone another week....
So haven't had any time after cutting the fenders to really run it but was clearing when I drove it. Still didn't clear with sway bar...
It is bare. Not sure if I see the need for a coating on it. The plastic SHOULD protect from gouges and such, it is why I sprung for the extra protection. I was not thinking of coating.
Who is using little ol 38's????
🤣🤣🤣🤣🤣
At full stuff and backing up I get rub.
This is about how much I trained
I think that is enough but it is not if I use sway bar disconnect. Gotta play with it to fine tune it.
Might just go to a 1 or 1.5 body and I think that would fix all kinds like...
I was a little paranoid about the single use bolts especially the nylock. Ordered from @flip but in talking with him he said they just re lock tight every thing. And that is what I did blue and red loc tite as needed. I did replace a couple of my locks but when you pull the factory bolts you...