Search results

I got caught in the rain with the roof off and noticed that the visors with the vanity mirrors basically fill with water and I'm pretty sure the HomeLink module got soaked and is toast now (no led, doesn't work). The vanity lights work fine though. I haven't seen any similar posts, but has...

I'm thinking of a set of rails that follow the contour of the rollbar sections above the doors and sticks out to form a typical rain rail so readily available roof racks could be used. I would think it would work for both hard and soft tops and may even prevent the soft top problem of strong...

Looking for a padded cover for the rear section of the rollbar that's exposed in the back. Has anyone found a good option for use with a hard top?

Fab’d these up to get me by until Rokblokz starts shipping. I doubled up some cheap RallyArmor ($25) flaps with a bent piece of 2" aluminum and rivets. Working well so far.

My Jeep had it, but the rear bars on my Bronco are totally unprotected. Looking for some padded cover (zip/velcro) for protection. I tend to pile a lot of gear in the back for beach/camping that will end up rubbing or leaning on the bars.

I'm interested in one of these: https://mobridge.us/product/mobridge-a2b-ford-amp/ I have LUX with the B&O. Was going to start with DSP tuning, replace the Sub, and see where things go from there.

Not sure how many others have this issue, but I'm constantly changing the headlight mode when I'm getting out of the driver's seat with my knee. It would be great if that knob was flush. Anyone with 3D modeling skills and a printer up for the challenge? I'm thinking of something with an indent...

Thoughts? I'll mainly be carrying surfboards and kayaks. Would have 2 sections per side, on the center panel and rear roof section. I'd like to be able to easily remove the bars when not needed and the tracks could could double as lift points for hanging in the garage, etc. Plenty of Jeeps have...

I'm not sure why Ford didn't add any FITS mount points in the Bronco. This would be a good project for someone, either 3D printed or CNC. Maybe a universal plate that can be attached. Console grab handle and back of center console seem like obvious places.

PPF installer tore it during removal. Part number on the boot is EU5T-14603-PB. Can't find it anywhere and parts counter only shows it as part of the entire carrier assembly. Any help would be greatly appreciated...