Ok, after reading the thread on suspension upgrades, I had pulled the trigger on these while they were on sale.
When I bought my Bronco, it came with a Rough Country 2.5" lift kit installed and 35" MTs from the dealer. Measuring everything before I started monkeying with it,. I was 40" from...
He is 17 years old, and loves working on the Bronco II, which we let him drive. I am not a good mechanic, I am not the best role model for learning anything to do with mechanical stuff, but I can usually stumble around and figure stuff out - I'm a decent "handyman".
He's been working on...
This is a non-comprehensive list of stuff you can do without needing a programmer/scan tool. Shamelessly copied and pasted from other sources, just putting it in one location. If there are more, or updates/corrections, I'm happy to update the original post with them. I made this so I can print...
So, I do a lot of driving in the mountains with a 7MT. You kind of get to make the decision on where you want the engine sitting.
A lot of hills and the speeds you drive around here, you get to make the choice - do I sit in a lower gear with higher engine RPM, or a higher gear with more turbo...
Has anyone seen anything like this? Mine Sync updates been stuck like this for a few weeks now. I figure it may just be Ford doing their slow rollout thing but it looks odd, and coupled with the fact that the Ford Pass App has never registered an update makes me curious.
I do have auto updates...
$20 obo. Will also accept beer. Shipping wouldn’t be worth it but could probably come up with a reasonable drop off point. Located in Central CA.
All hardware included. Ready to bolt in, no drilling needed and works fine with most mud flaps. Were used for about 9 months. A few dings on the...
Looking for the part number for the bulkhead fitting for the ELD on the rear end.
WPT-829 is the harness that plugs into either side of it, this is the connector that has one bolt that sits in the pumpkin for those two ends to plug into and provides the oil seal. It's on the rear upper right...
The tl;dr up front is I have a locker and I can't get it to work.
I bought a take off rear end back around Christmas so I could add a rear locker to my 4.46. Got it installed right after New Years.
Not having factory lockers, I ran the wiring to a relay. When I first installed it - it clicked...
So, a few months ago I upgraded the subwoofer in my 7ch non-B&O system. I have a Kenwood X802-5 amplifier, which is a 50x4 + 500W amplifier. I had replaced the stock sub with a Kicker 6.5" (150W RMS), but hadn't done a lot to it: I screwed in the speaker to the OEM housing, put some fiber...
So, I just noticed this today. My rear door is twisting. It looks fine at the hinges. At the latch, the top is pulling out by about 1/4” and the bottom is sunk in by about 1/4”
It does rattle a bit now, but feels tight and doesn’t have any abnormal play. The door opens and closes fine.
When I...
So my Big Bend didn't come with anything, and not knowing any better, I had just got a cheap Chinesium nerf bar and threw on the thing to start with. Its your standard oval side step
With the height of the Bronco (35" with 2.5" lift), they never really worked as I wanted. I'm a bit older and...