Added mudflaps this weekend

[Freedom5]

I put these on until I find a better solution. These are the front WeatherTech mud flaps

Sponsored

 

[Agrod]

I just finished the (almost no drill) mock-up install of the PlastiColor mud flaps in a SAS OBX. I used hardware I had at hand. Will replace with stainless steel hardware. I used M6 bolts and plastic spacers left over from a tv wall mount. I found a hole at the very bottom that was used for the additional bolt with spacers. I used the three body clip locations swapping one out for the shorter M6 bolt. I used double nuts to secure the fender liner and mud flap. I drilled a hole on the plastic end cap of the running board with the left over body clip. I used an universal nylon bumper clip to secure the top of the mud flap to a hole I drilled under the SAS flare near the fender clip bump.