Door Sill Protector

[bstoked]

Deck tape for skateboards is very cheap, comes in a large roll. Cut it how you want it.
Install in in door frames and on top of bumpers where you may need secure footing.

I've used this option for years! I always have a roll of clear grip tape on hand, but then again, I've been skateboarding for 35 years. LOL.

Sponsored

 

[BroncoSarge]

I wanted something thicker than a decal, longer to cover the whole area, no theme And doesn’t have Bronco inspired price increase. Ended up with these and like them.

https://www.amazon.com/dp/B09S3MR648?_encoding=UTF8&psc=1&ref_=cm_sw_r_ud_dp_JGR669W1N4NCB55QAVMX

 

[Karl_in_Chicago]

I wanted something thicker than a decal, longer to cover the whole area, no theme And doesn’t have Bronco inspired price increase. Ended up with these and like them.

https://www.amazon.com/dp/B09S3MR648?_encoding=UTF8&psc=1&ref_=cm_sw_r_ud_dp_JGR669W1N4NCB55QAVMX

How long have you had those installed? Any negative comments on Amazon were mostly focused on quality of adhesive tape and nobody really had any long term experience to share. They don't appear to have a 2-door anyway so for now it's moot for me . . . well that and still not having a Bronco, LOL. Just curious how they hold up (and even if they don't $30 isn't the end of the world.).

 

[BroncoSarge]

How long have you had those installed? Any negative comments on Amazon were mostly focused on quality of adhesive tape and nobody really had any long term experience to share. They don't appear to have a 2-door anyway so for now it's moot for me . . . well that and still not having a Bronco, LOL. Just curious how they hold up (and even if they don't $30 isn't the end of the world.).

Had them on my wife’s and my Bronco’s for over 6 months. Haven’t had issue. They are still stuck hard. Haven’t moved and they take a beating. I’m too short to get in without stepping on them. LOL

They are formed to fit. If you don‘t fit them just right, they will not seat fully. Maybe the complaints didn’t pre-fit like it did. I set them in place, used painters tape to keep them lined up and then pulled the backing off their tape.

If the only complaint was the tape, that’s an easy fix, though.

 

[TenSeven]

I wanted something thicker than a decal, longer to cover the whole area, no theme And doesn’t have Bronco inspired price increase. Ended up with these and like them.

https://www.amazon.com/dp/B09S3MR648?_encoding=UTF8&psc=1&ref_=cm_sw_r_ud_dp_JGR669W1N4NCB55QAVMX

I had the Fast Intentions sill protectors but found they were too small for the protection I wanted. I replaced them with these BESTAOO sill guards and like them very much.

I've had them on for about 4 months and they are still solidly attached. Even if they do work loose in the future, that is a simple fix with some 3M tape you can get at almost any auto parts store.

 

[BroncoSarge]

I

I had the Fast Intentions sill protectors but found they were too small for the protection I wanted. I replaced them with these BESTAOO sill guards and like them very much.

I've had them on for about 4 months and they are still solidly attached. Even if they do work loose in the future, that is a simple fix with some 3M tape you can get at almost any auto parts store.

I like them too. Solid and decent price.

 

[sylverknuk]

Don't have experience with Ecarzo, but I have enough concern about the lip interfering with dood closing properly that; Check out Sarah 'n Tunes Youtube channel; the girl is good. In addition to other great vids, there's one where she installs a similar product ... and ended up going with the skateboard tape. For me, I think I'll go with either the OE or fast intentions looks good too.

Sponsored