Welcome to the Forum! I've probably ordered 12-15 items from your company for my Bronco. Love all of them. Keep up the good work.
Think those will be added as of mid week.Love this!
The first one I'm going to wire up is glovebox lighting!! Glovebox and center console. We got a sticker for that??
Cyber Orange, of course.
On the list for next week's additions.
3M reflective vinyl is a little more expensive than some. We have white and black in stock for brake calipers already. Any other colors you want?
Thanks, great stuff. I just bought like 10 different items. Now I just need my Bronco to get built.
I’ll try as design notes on what this one gets wrong:Definitely can use the 2 door. People have been using standard blue for oval overlays and they don't look too bad on VB. We could try to get closer with a printed one though.
Could definitely use some non-signature headlights to help the member quoted below get some shots of the amber shortie overlays.
I was contemplating doing a video of the car wash that I use on the vehicle, but here is a photo. This is the end and there are 2-3 times as many brushes.
Once the vinyl is properly baked on (or a heat gun is used to firmly secure the edges), it should hold up pretty well. The only time anyone messages us for any type of vehicle is shortly after install and that is why we mention use of a heat gun / hair dryer or letting the vinyl dry out.
Thanks for the post. We'll knock something out next week.
If I wasn't consulting, I could probably get more of those shots. Our customers have left photos of various variants on various color vehicles. At least for some of the products. Have you browsed any of those?
I don't think a DIYer (that is also what I consider myself) can wrap those properly with vinyl. That's why I just did the flat surface facing forward. If I start an offroad company, I would scan these, make 3D prints, and test a cap to cover them. Then I would have it CNCd or open a new mold for abs which could be painted.
I need all of that.
Time, why you punish me? I need to get those done. Just been busy with the smaller stuff. Don't have a timeframe on it yet sadly.
Let me see if I can lure some people to stop by!
Alright love me some Texas, but the way the flag is, we would only have a small vertical section of the star. Message me or hit me up on the website chat if you have some design inspiration. Knocking out the oval overlay on the back might be easier for the Texas flag. At least we would capture a bigger chunk of the flag and could even change the scaling a bit.
Would it be possible for you to sell a complete set of interior stickers in a bundle? All grab handles, all vents and tabs, all Bronco inlays, all gear shifter inlays...etc.?
I have bought a number of things from you already, all look great but have a couple air bubbles. Any suggestions on how to get those out? Maybe make a pin whole and press out that way? For suggestions, how about Area 51 color that will go over the stickers on the door jams. Kinda don’t won’t to take them off, not sure why… kinda feel like I may need them at some point.
.
Love your aux switch stickers, I'll be ordering some soon, once my damn fog/driving lights come from Diode Dynamics.
Are you able to advise on if their are any temperature limits in which your stickers can be applied?
