Zone Lift with 37" Tires Review

[texasmark04]

Just got the rig back today from 4WP. I read a number of review of this site. Thanks to @Big Mak who posted about a very similar setup to what I was thinking of going with and convinced me to go that route. I have a 2022 OBX Sasquatch 4 door. Decided to try out the Zone lift since it got very good review on here, and I didn't want to go 3" or higher, but wanted the clearance for the larger 37" tires. So far plenty of room, no rubbing at all. I don't hard trail with my Bronco, so not too worried about that. Mainly will see beach/sand/trails.

Here are the mods I did with before and after pictures:

• Lift: Zone 2" Lift Kit (ZONF1221): CJ Pony - ZONF1221 Zone Offroad Products Lift Kit 2" Bronco 2021-2022
• Rough Country Tailgate Reinforcement Plate (51052): CJ Pony - 51052 Rough Country 2021-2022 Bronco Tailgate Reinforcement Plate
• Tires: Mickey Thompson Baja Boss (M/T90000036824): 4WP - Mickey Thompson 37x12.50R17LT Baja Boss A/T
• Wheels: Fuel D751 Matte Bronze w/ Black Ring (D75117908450): Fuel - D751 Block 17x9/1+ Offset/6x139.7 Bolt Pattern

Before Pic of Bronco:

After Pic of Bronco:

Sponsored

 

[Freedom5]

Waiting to have my zone 3" installed in a week and a half. 37s on 17x9-12

 

[Cysquatch]

Went with a Zone 3” adventure lift (2-door ver.), 37” Ironman M/Ts (yeah, yeah, they ain’t KOs but $200 each? Had to!), and Method 312 double blacks (17x9, -12mm offset). No rubbing and about an inch of poke. I originally had the 37s on the Sasquatch wheels (+35mm offset) with 1.5” spacers (not a fan).
The 9” wheel and new offset allowed me to ditch the spacers.

Rides good but you definitely notice the difference (sluggish off the line and a smidge of body roll in fast turns). I expected this considering these tires are made for off-road and are 20lbs heavier and 1.5” taller than the stock 35’s.

Can’t wait to hit the trails where my BaseSquatch was draggin’

 

[Freedom5]

Zone 3" lift and 37/12.5-17(-12)

 

[Oldhippie]

I am also planning the zone 3” and 37”s...if I ever get a Bronco...

 

[Kibbie13]

Went with a Zone 3” adventure lift (2-door ver.), 37” Ironman M/Ts (yeah, yeah, they ain’t KOs but $200 each? Had to!), and Method 312 double blacks (17x9, -12mm offset). No rubbing and about an inch of poke. I originally had the 37s on the Sasquatch wheels (+35mm offset) with 1.5” spacers (not a fan).
The 9” wheel and new offset allowed me to ditch the spacers.

Rides good but you definitely notice the difference (sluggish off the line and a smidge of body roll in fast turns). I expected this considering these tires are made for off-road and are 20lbs heavier and 1.5” taller than the stock 35’s.

Can’t wait to hit the trails where my BaseSquatch was draggin’

This looks great! Do you know what your roof height is with the Zone 3” and 37’s? Wanting the same setup but hesitant with my garage door height!

 

[Cysquatch]

This looks great! Do you know what your roof height is with the Zone 3” and 37’s? Wanting the same setup but hesitant with my garage door height!

I’ve made some changes since the original post. I’m on Kings now and I’m sitting just under 77” (probably 76 3/4”). Easily fits in the garage.

 

[Oldhippie]

Got 3” zone lift done…drives and rides fine with rock jock sway bar bracket… may wait on 37s a while…

Sponsored