About to chuck these Icon EXPs over a cliff

[Tricky Dick]

Are these springs right? They're supposed to be front Sasquatch springs. I've been fighting this thing all night and I can't get the isolators to fit into the spring. One end of the spring is pinched down and no matter which end I put up it won't fit in Icon's isolator or Ford's.

From the instructions it appears the pinched end should point down but it's not going to happen.

Sponsored

 

[akturbo]

Is the rubber part wrong? Dunno man!

https://www.bronco6g.com/forum/thre...between-spacers-and-threaded-coilovers.42536/

 

[CarbonBronco]

I have nothing good to say about icon….

 

[Tricky Dick]

Is the rubber part wrong? Dunno man!

https://www.bronco6g.com/forum/thre...between-spacers-and-threaded-coilovers.42536/

Maybe? I could trim it down but I'd rather not if something is wrong.

@Dusty at ICON any ideas?

 

[kodiakisland]

Are you sure you have springs for the Bilsteins and not the Hitachis? I've had both and just remember they were different widths on the bases but can't remember which was more narrow.

 

[Tricky Dick]

Are you sure you have springs for the Bilsteins and not the Hitachis? I've had both and just remember they were different widths on the bases but can't remember which was more narrow.

See that's what I'm wondering, if these are correct. The tags are in rough shape so I don't have much to go on.

 

[BigMeatsBronco]

I don't think they are SAS springs

 

[kodiakisland]

Just looking through some of my pictures, none are really good to distinguish between the two, but it appears the Bilstein springs barely step down on the last coil. The Hitachis have a very obvious stepdown to about half width on the last coil

 

[Tricky Dick]

I don't think they are SAS springs

Just looking through some of my pictures, none are really good to distinguish between the two, but it appears the Bilstein springs barely step down on the last coil. The Hitachis have a very obvious stepdown to about half width on the last coil

I think you guys are right. Here's some squatch coils currently on the marketplace and they look more open on the bottom.

 

[kodiakisland]

Here’s the front Hitachi spring.

 

[Tricky Dick]

Here’s the front Hitachi spring.

With a blue/purple/blue tag.... Dammit. These are Hitachi coils.

 

[IwannaGOfast]

Talk about frustrating. Where did you obtain those coils?

 

[Tricky Dick]

Talk about frustrating. Where did you obtain those coils?

A member here. I wanted V6 coils to help support the winch weight.

 

[Tricky Dick]

2.3 base 4dr. B/P/B

 

[Tricky Dick]

All squatch coils I've found have been Green/Red/Green or Green/White/Green.

I guess that settles it.

Sponsored