Introducing our new frame horn reinforcement plates

[Tricky Dick]

Now that a few bumper mounts have bent under hard pulls it's become apparent that the thin OEM mounts aren't sufficient. So Tricky has brought the beef. These will ship 5/25. Pre-order HERE

Unfortunately due to low margins in an attempt to keep pricing competitive these are not eligible for any discounts. If demand is high I can revisit that in the future.

Sponsored

 

[GreyZ]

Can these me used without a winch to reinfoce the stock recovery points? Works with capable and mod bumpers right?

 

[Tricky Dick]

Can these me used without a winch to reinfoce the stock recovery points? Works with capable and mod bumpers right?

You can and it's probably wise to do so after one of our members bent his just getting yanked out of sand. The entire assembly sits behind the stock mount plates so all OEM bumpers are compatible.

 

[22Badskwatch]

is this something that will help prevent twisting/damage if using a winch setup like the Rough Country high winch mount?

 

[Tricky Dick]

is this something that will help prevent twisting/damage if using a winch setup like the Rough Country high winch mount?

Why yes, yes it is. It should be the end of that problem for good.

 

[GloNDark]

YES!!! I've been waiting for these. Pre-order done!!

 

[Bearcat1]

ordered

 

[Tricky Dick]

YES!!! I've been waiting for these. Pre-order done!!

I think I'm even more excited to get these out to you guys. It sucks breaking stuff that's too light duty.

 

[GloNDark]

Yes it does. I put the Maxlider bumper on my Bronco and then started seeing all the threads about bent frame horns. I've used it VERY sparingly a couple of times. Glad I won't have to stress it as much.

Thanks for putting these out for everyone.

 

[P52Ranch]

Could these be further strengthened with some welds placed at the bends and where the tabs bend over? Any excuse to use my welder is a good one.

 

[Tricky Dick]

Could these be further strengthened with some welds placed at the bends and where the tabs bend over? Any excuse to use my welder is a good one.

They come welded, I just didn't have a pic handy. Will update that later.

 

[604Bronco]

So Tricky has brought the beef.

Sounds like a cheap slogan knock off...

 

[Copperhorse73]

You should sell a lot of these , well done!

 

[BAUS67]

Sounds like a cheap slogan knock off...

 

[Felix808]

is this something that will help prevent twisting/damage if using a winch setup like the Rough Country high winch mount?

Why yes, yes it is. It should be the end of that problem for good.

Especially if you use all the supplied hardware

Sponsored