Recent content by Klunatic

I measured and emailed them the correct post dimension's to get a better fit. They shipped them out the next day and it took care of the fit issue. The post would not work with the height adjustment on the seat as the locking tab on the seat is angled and not straight. I took a grinder wheel...

Butterfly toggle on bottom of post.

I called up the company and told them it didn't fit and sent them the measurements of the OEM headrest post. They sent me a new set of post that were factory dimensions. Send the customer service am email.

No No it is locked into the seat

www.headrestsafe.com

It locks in place and can't be pulled out of the seat. As you indicated it would be useless otherwise.

www.headrestsafe.com

Where do you put your gun if you have to go into a restricted location? A safe is not a substitute for a holster for carry. Its to secure the firearm temporarily if you can't carry a firearm into a restricted location like Government building, Post office, airport, school etc... It is also...

I posted this in another thread but I freaking love this solution for pistol storage. https://www.bronco6g.com/forum/threads/where-to-mount-a-gun-safe-admin-warning-no-politics.23038/post-1853791

Numerous reasons, If I need to go into a restricted location such as my child's school, Post office, Government office. I am not going to simply leave it in the vehicle unsecured.

This is my solution https://www.bronco6g.com/forum/threads/where-to-mount-a-gun-safe-admin-warning-no-politics.23038/post-1853791

https://www.bronco6g.com/forum/threads/where-to-mount-a-gun-safe-admin-warning-no-politics.23038/post-1853791

Success! I have found the solution that hit the most important features for me; secure, out of sight, biometric access. I received the Headrest safe and installed it today. The combo head rest and companion safe were $585.00 purchased from www.theheadrestsafe.com. Here are few pictures of...

I think may have found a solution that works for me. I ordered the Headrest safe and should have it in hand next Tuesday. I will report back on fit and finish as well as security. https://www.theheadrestsafe.com/

The hot wire is connected to the upfitter wire in the passenger side rear fender and grounded in the same location on the body at an existing bolt. I fed a 2 conductor wire up to the controller located in the roll bar cover and spliced the hot and ground wire to the controller.