- First Name
- Nick
- Joined
- May 10, 2026
- Threads
- 4
- Messages
- 22
- Reaction score
- 55
- Location
- Chicagoland
- Vehicle(s)
- 2026 OBX SAS, 1969 Olds Cutlass
- Your Bronco Model
- Outer Banks
- Thread starter
- #1
I'm 6'6" and (unfortunately) in most cars my eyes are level with the rear view mirror which blocks my field of vision a bit.
I'm glad that the Bronco has an arm that is double adjustable, I can rotate the whole arm up at the window pivot, and then adjust the angle of the mirror itself properly. However, I'd like to lift the mirror another inch or so if possible. Good news is, there is room above the mirror to make this happen.
I see two reasonable options. Replace the arm with one that is slightly longer and has a a bend or "S" curve to it... I've never seen anything like this before. Does it exist?
Or, if the arm is not easily removable... cut it in half and add an adaptor that lifts it up. I bet this could be 3D printed.
Something like this where the two halves of the factory arm slip into a snug fitting adaptor, could have a couple holes for set screws to keep it secure.
Image not to scale
I've seen a few posts about this, glad to know I'm not the only one. This may be a solid little item for somebody to make and sell.
I'm glad that the Bronco has an arm that is double adjustable, I can rotate the whole arm up at the window pivot, and then adjust the angle of the mirror itself properly. However, I'd like to lift the mirror another inch or so if possible. Good news is, there is room above the mirror to make this happen.
I see two reasonable options. Replace the arm with one that is slightly longer and has a a bend or "S" curve to it... I've never seen anything like this before. Does it exist?
Or, if the arm is not easily removable... cut it in half and add an adaptor that lifts it up. I bet this could be 3D printed.
Something like this where the two halves of the factory arm slip into a snug fitting adaptor, could have a couple holes for set screws to keep it secure.
Image not to scale
I've seen a few posts about this, glad to know I'm not the only one. This may be a solid little item for somebody to make and sell.
Sponsored