1” lift for SAS?

[KompressorV12]

I don’t intend on going 37s but want a slightly higher stance. When my bronco is loaded with gear when overlanding I lose clearance. I want a 1” (non leveling) kit. Will this put me out of tolerance and risk over extending angles?

Sponsored

 

[cmcbronco]

Sounds like old man emu would fit your needs best.
https://www.bronco6g.com/forum/thre...ger-suspension-of-2021-4dr-ford-bronco.45423/

 

[Lurker B6G]

If you use a 1" level kit in the front (either Zone or Rough Country) and a Fabtech 1.5" level in the rear you will get...

0.94 front/0.88 rear lift.

No need to dissassemble the coilovers for this small of a lift, and no real risks with the angles. Done and done.

 

[KompressorV12]

If you use a 1" level kit in the front (either Zone or Rough Country) and a Fabtech 1.5" level in the rear you will get...

0.94 front/0.88 rear lift.

No need to dissassemble the coilovers for this small of a lift, and no real risks with the angles. Done and done.

I like the sound of that

Sponsored