3D files for BRONCO lettering

[Lowzee]

hey all,

Does anyone have STL files for the BRONCO lettering in the grill? I'm looking to 3D print some custom fun that'll snap over the letters, hoping someone has the letters available somewhere.

Thanks!
David

Sponsored

 

[BigRed13]

Following.

 

[Ground_zero298]

Following.

Bet Ford is too.

 

[Lowzee]

I’ve measured off a letter, just to get the outer dimensions, may/may not create the individual letters, just need a solid reference to snap something over them.

 

[BigRed13]

Bet Ford is too.

Ha ha, oh I'm sure they are. Once it hits the internet once though good luck stopping all the local guys from printing them and selling them to each other. Sometimes the juice ain't worth the squeeze.

 

[Theherofails]

https://www.bronco6g.com/forum/threads/bronco-logo-font.9110/page-4


You could easily create your own in Fusion 360 from the font provided in this post.

 

[JDav]

From an earlier thread: https://www.bronco6g.com/forum/threads/ford-style-lettering-to-3d-print-for-projects.48515/

 

[Lowzee]

https://www.bronco6g.com/forum/threads/bronco-logo-font.9110/page-4


You could easily create your own in Fusion 360 from the font provided in this post.

GAH Thank you for the font!! that'll make this much easier

 

[Lowzee]

Nope, that font isn't the same used on the grill, the letters are 1:3 (32mm x 92mm) very wide

 

[Lowzee]

Although these are close, some stretching but I think this will do.
https://www.bronco6g.com/forum/threads/ford-style-lettering-to-3d-print-for-projects.48515/

 

[Theherofails]

Nope, that font isn't the same used on the grill, the letters are 1:3 (32mm x 92mm) very wide

Someone in the thread gave the correct dimensions for stretching the letters I believe.

Sponsored