Bulletpoint Mounting Solutions

[Gypsy]

Absolutely! I went out and measured and I do have the standard length arms...

I appreciate all the trouble you went through I appreciate more than you know.

Sponsored

 

[PaulNY]

For those of you that installed this mount, did you use the included self-tapping screws to secure to the dash, or is the supplied 3m tape good enough? Admittedly, I am seriously considering this mount as I have used their products before but am hesitant to put holes in my dash.

 

[TiKi-Bronco]

Yes Very Gucci. Great fit & finish. Very robust. Very satisfied.

I was searching for mounts and saw this post. Anyone who likes 45-70 Govt has to know heavy duty. Sold me on BulletPoint.

 

[bkfit]

I was searching for mounts and saw this post. Anyone who likes 45-70 Govt has to know heavy duty. Sold me on BulletPoint.

Silenced 45-70 too.
You will like the Bulletpoint set up. Very Nice.

 

[ldcobb2]

Has anyone used the rubigrid with the AR SLAP? I just went to fit mine and the rubigrid blocks the two outer holes on the SLAP. I was still hoping to have access to those.. anyone have a better solution than cutting the rubigrid?

 

[29AGAIN]

Thank you for your response. I was looking for something that would sit lower, closer to me and out of my line of vision.

Was it difficult to install?

I appreciate you taking the time.

Not necessarily closer to you, but def lower and not in your line of vision: PROCLIP.


Personally I can’t abide all of the brackets, rods and tubes on top of the dash.

 

[KreeHBronco]

Has anyone used this company's mounting bracket for their Bronco? Id so what do you think of it? TIA

https://www.bulletpointmountingsolutions.com/pages/2021-ford-bronco-phone-mounts

I have and it worked well for me on my 2026 4-dr Badlands. My install used parts from Amazon to build two SafeMag IQ charger ports for my and my wife's phones. They have worked very well. Here is a photo.

Sponsored