Door net panel replacement -> Add-On's??? Brand's....

[psdtime]

They do look the same. The company on Amazon I ordered from was called LEPZ at the time so maybe now something else as their page has only a few Bronco things...

I have the Mabett center console arm rest and it is nice quality - so probably still a good purchase of these pockets from them!

These are the ones that I had that I ended up getting rid of because they were so big that it touched my leg when driving. I did really like them, but I started fixating on it and it drove me nuts. If it wasn't for me reading a post like this, I probably wouldn't have noticed.

Sponsored

 

[totaljustice]

Hey everyone,,

I am not feeling the door-net holders on the Bronco and want to add some of those new plastic add-ons for cups and phones etc... What are some good brands that are reliable and durable and wont pop off. I like the screw on units, not double sided tape. I don't mind drilling either, but would like to use existing holes would be ideal. Thank you in advance for any 411 anyone can provide me.

Cheers,
Anthony

If you end up getting one that screws into the existing holes go very, very, VERY light on the torque when tightening them. Lots of us have stripped the clip retainers that Ford uses. I ruined 4 myself and I knew about the cheap clips. Somewhere around here is a discussion about the mess and a guy found a solution by switching all the clips to cage nuts and he provides a link. Once you swap them out you can come onto 'er.

 

[totaljustice]

And you can keep the net underneath the bolt on one's too!

 

[Beach_Bum]

If you end up getting one that screws into the existing holes go very, very, VERY light on the torque when tightening them. Lots of us have stripped the clip retainers that Ford uses. I ruined 4 myself and I knew about the cheap clips. Somewhere around here is a discussion about the mess and a guy found a solution by switching all the clips to cage nuts and he provides a link. Once you swap them out you can come onto 'er.

Here is the post that illustrates the replacement.

 

[Monte87]

Are you talking front? If so, there are a ton of good no-drill options. I have tried a couple. The first ones (Mabett) I got and I loved everything about them except they touched my calf while driving. They were too large. I ended up with some that are made of TPU (rubber feeling like a cell phone case) they work great too (IAG). These were both Amazon items. If you want something more unique, or US made, there are plenty of other options. If you are looking for back door pockets, I haven't found any that didn't require drilling, but I'm still looking.

Hey man,

Thanks for the reply!!! I am looking for front and back. I wanna get them in 1 shot and be done. The nets suck!!! Appreciate your help!
Anthony

 

[Monte87]

Thank you everyone for all your help, suggestions, opinions!! You guys rock!!! I am going to reply individually soon, just got home from work and exhausted... Will do tomorrow!!!!

Cheers, Anthony

 

[Gbauer]

If you have a 3d printer go to the 3d print thread. There's a real nice cup holder in there you can print.

Sponsored