Hella Mount for Brush Guard

[gooby]

Is there a mount available for attaching traditional lights to the brush guard already on the market? Not interested in LED light bars. I know lots of companies make universal roll bar light mounts, but I haven't found anything that could support a set of Hellas.

Sponsored

 

[cullenmcm]

I've been looking all over for something similar to this and have so far come up empty. If someone made some similar brackets that would fit the bull bar I'd be a buyer. What would make it even better is if they could adjust the offset as to not obstruct the camera.

 

[gooby]

I've been looking all over for something similar to this and have so far come up empty. If someone made some similar brackets that would fit the bull bar I'd be a buyer. What would make it even better is if they could adjust the offset as to not obstruct the camera.

if there really isn't something available then I'm going to try to have one made. the rendering is from a quick prototype I mocked up but I wanted to make sure there wasn't an alternative available before I went through with it.

 

[threeonone]

Probably just best to go to a fab shop and ask for one made.

 

[AlexInNY]

I have a Big Bend with plastic bumper and am looking into adding round Hella or Cibie lights using this brush guard:

https://www.roughcountry.com/ford-nudge-bar-51045c.html?find=2021-ford-bronco-4wd-784415

Haven’t verified if the light stems will fit the bar holes but will report back when I finalize the gear.

 

[PanAfrica]

So I mounted these Hella 500's on my truck.
I bought some hangers on ebay - from one of the big parts house. Don't remember name, but they were 4 for $26. Need 2" dia. clamps.
I really like the "ole school" vibe -

 

[alexryer]

Is there a mount available for attaching traditional lights to the brush guard already on the market? Not interested in LED light bars. I know lots of companies make universal roll bar light mounts, but I haven't found anything that could support a set of Hellas.

https://axiaalloys.com/product/large-light-mount-for-7-and-larger-hid/

 

[gooby]

https://axiaalloys.com/product/large-light-mount-for-7-and-larger-hid/

I used those for some Hella Rallye 4000 and it is very tight between the back of the bulbs and the grill. I put some thin rubber on the back of the bulb to keep it from vibrating. I also flipped the bulb itself (not just the lens) so that “Top” is up. I may drill a small drain hole at the bottom but these aren’t sealed lamps so it may not be needed.

Sponsored