How to mount 8” driving lights to modular bumper?

[GPPBronco]

https://specialtyperformanceparts.c...ight-bar-mounts-for-30-light-bars-or-2-lights

Not sure how the mounting brackets in your link relate to my question about wiring…

Sponsored

 

[ATLBronco75]

Not sure how the mounting brackets in your link relate to my question about wiring…

I meant to quote the guy before you who was asking about those brackets.

 

[805BaseSquatch]

Do you have aux switches? If so, any info on how you wired these up would be appreciated! Did you purchase the wiring harness? And, Are the DRLs functional as well?

Yes I have the AUX switches. These are wired to AUX switch 1.

There is a wire thats just behind the hood latch that I used for these. I used the wiring harness they come with and combined the DRL lights with the main lights. The hardest part was twisting 4 wires together and connecting them to a single power wire. Each light has a water-proof plug and then three 3 wires (2 positive for Lights and DRL, 1 ground). I twisted the 4 total positive wires together and used a solder heat shrink wire connector to connect them to my power wire, and did the same with the 2 ground wires. I put some plastic protective wrap around the wire and did my best to zip tie it all out of sight.

If you don't have aux switches you could easily order a wiring harness and route the switch through your firewall.

I routed the power wire behind the drivers side headlight and front quarter panel, along with a wire to the negative terminal on the battery.

Link to lights: https://www.led-colight.com/product...offroad-driving-lights?variant=40096897630313

link to solder wire connectors: https://www.amazon.com/Connectors-H...cphy=9031150&hvtargid=pla-1019970495303&psc=1

Sponsored