Mabett door handle trays - fit back door of the 4 door?

[Browp24]

Anybody know if these fit the back door of the 4 door?

Mabett 2PCS Car Organizer Inner Door Handle Tray for Ford Bronco Accessories 2021 2022 2/4Door Create Car Storage Space by Handle Pocket https://www.amazon.com/dp/B09WR3FM5S/ref=cm_sw_r_apan_i_1YK94PWQ6WRPRC7QT2ZM

Sponsored

 

[cpsocal]

I want to know the same. I only bought 2 for the front doors and they are great! Would love to have them for the back doors as well. @Mabett will these fit the back doors as well?

 

[Herbie]

I bought two sets as they were supposed to fit back as well. My two fronts are perfect, the backs had a little gap and have since fallen off. Hope that helps.

 

[cpsocal]

I bought two sets as they were supposed to fit back as well. My two fronts are perfect, the backs had a little gap and have since fallen off. Hope that helps.

Thanks for taking one for the team! Exactly what I was looking for. Bummer it didn't work. Maybe they'll come up with a better rear door tray and send you a free set.

 

[5280Bronco]

I bought two sets as they were supposed to fit back as well. My two fronts are perfect, the backs had a little gap and have since fallen off. Hope that helps.

Did they fall off due to the size being off? Or the tape not holding? If it's the latter, I'll have to watch the fronts I put in to make sure they don't fall off. I did use adhesion promoter so hopefully that helps.

 

[Herbie]

Did they fall off due to the size being off? Or the tape not holding? If it's the latter, I'll have to watch the fronts I put in to make sure they don't fall off. I did use adhesion promoter so hopefully that helps.

I think it was a combination of fitment and the not so great tape that was included. I might try the backs again. What adhesion promoter did you use? The one side is so thin with barely any surface space as you know, that is probably some of the issue.

 

[5280Bronco]

I think it was a combination of fitment and the not so great tape that was included. I might try the backs again. What adhesion promoter did you use? The one side is so thin with barely any surface space as you know, that is probably some of the issue.

Makes sense. I used this one:
https://www.amazon.com/gp/aw/d/B018WQ2T3O?psc=1&ref=ppx_pop_mob_b_asin_title

 

[Browp24]

Thanks for the info if you could let us know how it works with the adhesive promoter that would be great

Sponsored