- Thread starter
- #1
Hi all, I've looked all over but haven't seen anyone graciously post any step by step instructions on how to install fog lights. Here's what I have:
- Base Sasquatch with base plastic bumper
- Aux switches (ditch lights installed)
- I am going to buy a after market bumper - probably this one: https://dv8offroad.com/products/oe-...w-profile-front-bumper?variant=39546931904583
- I am going to buy these lights with all the harnesses: https://dv8offroad.com/products/3-inch-led-pod-lights-be3ew40w?variant=39546864173127
Question is, since I am not wired for fogs already, and I doubt there is any "pre-wired" harnesses on my base, how would I get everything wired for the new fogs to the aux switches?
Also important note - I am a novice at this stuff ha. Thanks
- Base Sasquatch with base plastic bumper
- Aux switches (ditch lights installed)
- I am going to buy a after market bumper - probably this one: https://dv8offroad.com/products/oe-...w-profile-front-bumper?variant=39546931904583
- I am going to buy these lights with all the harnesses: https://dv8offroad.com/products/3-inch-led-pod-lights-be3ew40w?variant=39546864173127
Question is, since I am not wired for fogs already, and I doubt there is any "pre-wired" harnesses on my base, how would I get everything wired for the new fogs to the aux switches?
Also important note - I am a novice at this stuff ha. Thanks
Sponsored