- Thread starter
- #1
I purchased the front and rear flaps for a '22 2DR Badlands with the rock rails. I am having a couple of fitment issues and was hoping for some help.
1. On the drivers side, the metal bracket is at a bit of an angle and as such the flap actually touches the rock rail at rest, is this by design? Pictures I've seen show a fairly decent gap between the 2.
2. I can't get the passenger side on at all due to the hole for the plastic clip (inside most hole) not lining up. I can get the clip in, but at such an extreme angle it doesn't secure properly. Hard to get photos, but below you can see the "U" cutout is touching on the bottom of the rail/bar and still not close enough to the hole to fit.
The "U" shape is touching on the bottom and can't go up any further to meet the hole in the fender.
Fuzzy pic, shows the hole doesn't line up.
hard to see but the plastic clip is a pretty extreme angle to clear the hole, and as such won't screw down and secure.
For reference, here's the fit on the drivers side which is spot on (besides the wonky metal bracket).
I haven't bothered to do the rears yet as I want to see if these will actually fit my vehicle.
Thanks in advance!
1. On the drivers side, the metal bracket is at a bit of an angle and as such the flap actually touches the rock rail at rest, is this by design? Pictures I've seen show a fairly decent gap between the 2.
2. I can't get the passenger side on at all due to the hole for the plastic clip (inside most hole) not lining up. I can get the clip in, but at such an extreme angle it doesn't secure properly. Hard to get photos, but below you can see the "U" cutout is touching on the bottom of the rail/bar and still not close enough to the hole to fit.
The "U" shape is touching on the bottom and can't go up any further to meet the hole in the fender.
Fuzzy pic, shows the hole doesn't line up.
hard to see but the plastic clip is a pretty extreme angle to clear the hole, and as such won't screw down and secure.
For reference, here's the fit on the drivers side which is spot on (besides the wonky metal bracket).
I haven't bothered to do the rears yet as I want to see if these will actually fit my vehicle.
Thanks in advance!
Sponsored