What did you do TO / WITH your Bronco today? 👨🏻‍🔧🧰🚿🛠

[BD6G]

Received my archetype racing SLAP/BAM rail about to install shortly. Quality is outstanding on this piece.

Installed my hood deflector in preparation for light bar install tomorrow hoping it will assist in keeping the. Noise down. I am very happy with the fit and finish of the deflector.

Sponsored

 

[Max1h]

Cottonwood Trail, UT didn’t snap to many photos for this one was an easy scenic trail

 

[Bigred86]

Took my hardtop off for the first time today!

 

[dgorsett]

Wired in the Curt 58996 towed vehicle wiring to replace my clamp on lights.

If you are going to use Curt towed and tow wiring Curt now has a short cut to wire both. You can use Curt 58996 (non led) towed harness and add 58920 for your tow lights. With these you won't have to daisy chain like I did.

And ran it through a car wash.

 

[Trees]

Not technically today but yesterday!

Roof rack off, sunrider on! Its summertime in Chicago!

 

[THE Buckeye Bronco]

Installed the RockWorkx top two thumb screws. They weren't available when I ordered the set for the bottom. Now I can remove the top without the need of the torx tool.

 

[Cat]

Why did you do this?

 

[V1Rotate]

Why did you do this?

We’ve wheeled the heck out of ours so far and I want to start with some good clean gear oil after breaking it in for 10k. I’m interested in longevity. FWIW Several buddies also got under filled from the factory and wrecked their diff in under 15k.. wasn’t the case for me (checked the level a while back) but if you haven’t I’d check your level

 

[BD6G]

Installed the 40 inch Ford Performance/Rigid light bar.

installed the archetype racing SLAP/BAM mount.

 

[TonyM]

Behind the back seat Amazon addition. Need some light back there!

 

[AKBronc49]

It was the other day, but got a speeding ticket. The 2.7 is just a caged beast I tell ya

 

[c72k]

Finally received mine today after nearly 2 years!

 

[Cat]

We’ve wheeled the heck out of ours so far and I want to start with some good clean gear oil after breaking it in for 10k. I’m interested in longevity. FWIW Several buddies also got under filled from the factory and wrecked their diff in under 15k.. wasn’t the case for me (checked the level a while back) but if you haven’t I’d check your level

Thank you for this info. I took mine in today for my 15K check-up. I also wanted the dealer service dept to swap out the OEM diff cover for the one I received from @metaltech (that I hand-painted like theirs...shamelessly). But, I forgot to bring the Metaltech bolts, so they ended up putting the OEM diff cover back on. Hopefully, it got filled properly.

 

[V1Rotate]

Thank you for this info. I took mine in today for my 15K check-up. I also wanted the dealer service dept to swap out the OEM diff cover for the one I received from @metaltech (that I hand-painted like theirs...shamelessly). But, I forgot to bring the Metaltech bolts, so they ended up putting the OEM diff cover back on. Hopefully, it got filled properly.

It’s easy to check the fill level.. should be right up to the fill plug. Of course you’ll have to do it again if you want to swap covers

 

[NoloBronco]

Behind the back seat Amazon addition. Need some light back there!

Link please for the light.

Sponsored