Help Identify a Bronco Exterior Accessory / Part (Answer: Pinch Weld Cover)

[03LX470]

Hi

I would like to direct your attention to the horizontal area of the body below the doors where normally there are a few holes and the area sort of looks raw or unfinished although it is painted in body color.

I’ve attached a picture with that area being covered with plastic cladding. As you notice it is covered by a black plastic cladding and this gives a “neat” look hiding the holes and the “raw” look.

Anyone know if this plastic cladding is a Ford or aftermarket accessory or part?

Thanks!

Sponsored

 

[BigBlue7]

https://accessories.ford.com/bronco-4dr-2021-2023-rock-rails

 

[HeHateMe]

Hi

I would like to direct your attention to the horizontal area of the body below the doors where normally there are a few holes and the area sort of looks raw or unfinished although it is painted in body color.

I’ve attached a picture with that area being covered with plastic cladding. As you notice it is covered by a black plastic cladding and this gives a “neat” look hiding the holes and the “raw” look.

Anyone know if this plastic cladding is a Ford or aftermarket accessory or part?

Thanks!

Pinch weld covers...

Many make them now.

The ones you posted do look like the Ford Accessories ones from Bushwacker I think it was. I have them on mine. Bought with Ford points.

 

[RBJRBJ]

The unfinished looking bottom below the body with holes is a pinch weld. Several aftermarket vendors make pinch weld covers, which are bolt on and hide the unsightly pinch welds. I installed DV8s pinch weld cover on my Bronco Wildtrak 2-door. I liked the DV8 for 2-doors since it’s one (1) piece of steel, most are two (2) pieces bolted on and together. Photo attached, just expand to view. $80 for the 2-door covers.
https://dv8offroad.com/collections/ford-bronco-accessories/products/2-door-bronco-pinch-weld-covers

 

[03LX470]

Pinch weld covers...

Many make them now.

The ones you posted do look like the Ford Accessories ones from Bushwacker I think it was. I have them on mine. Bought with Ford points.

Thank you so much!

Would you have the Ford part number, please?

Thanks again!

 

[j_marinelli]

Thank you so much!

Would you have the Ford part number, please?

Thanks again!

2 door: BUS-14121

4 door: BUS-14117

 

[Billy Goat]

I ran across the bushwacker pinch weld covers when I was looking for something to put in the threshold besides anti-skid tape to help with footing and keep the scratching down. On a side note, they added an extra layer of protection and reinforcement when I installed the rock slide engineering slider steps as well

Sponsored