Broaddict trail deck installed

[KreeHBronco]

I’ve seen other reviewers where people just replace the pullout handle with a soft grab handle to make it fit with existing tables. Now I remember. Been awhile since I read or watched in YouTube.

While I think that helps with some, I don't believe it will solve the problem with all tail gate tables. I don't think it will work with my Broaddict tail gate table. I found it odd that it isn't compatible with the pre-existing Broaddict tailgate table.

Sponsored

 

[Run3gun]

While I think that helps with some, I don't believe it will solve the problem with all tail gate tables. I don't think it will work with my Broaddict tail gate table. I found it odd that it isn't compatible with the pre-existing Broaddict tailgate table.

I totally agree my table Molle table was too thick that right corner bumps out just an inch too much . They should offer a huge discount to anyone that bought the first gen table that wants to add the slide

 

[EOD98]

As requested. Here are some shots of my Broaddict TrailDeck and shelf. You can see that I used boat decking (peel and stick on) to cover my sound deadening and to give it a nice clean look.

Ignore the amps in the cargo floor. I just started an install and haven’t made a proper amp board. I have a Musway M6 Pro DSP mounted to the underside of my rear drivers side seat. The person plug popping out from under the rear seat is a quick disconnect for my downfiring sub enclosure. I wanted a simple option to remove it and not leave bare speaker wires laying around.

 

[PWillette]

I wish Broaddict would come up with an updated design which is 1 to 1.5in shorter to allow compatibility with existing tail gate tables.

^This^...shorten the deck to flush where the handle mounts and it would work with just about any tailgate table. Probably done intentionally so they can sell more of their tables.

Also, IMO the handle is useless...when I pull out the deck or drawer I simply unlatch both sides simultaneously and pull. Makes no sense to me to unlatch and then use the handle.

 

[Deadpool392]

As requested. Here are some shots of my Broaddict TrailDeck and shelf. You can see that I used boat decking (peel and stick on) to cover my sound deadening and to give it a nice clean look.

Ignore the amps in the cargo floor. I just started an install and haven’t made a proper amp board. I have a Musway M6 Pro DSP mounted to the underside of my rear drivers side seat. The person plug popping out from under the rear seat is a quick disconnect for my downfiring sub enclosure. I wanted a simple option to remove it and not leave bare speaker wires laying around.

Is that the BroAddict floor liner for the TrailDeck?

 

[EOD98]

No, it’s boat decking stuff I put in myself. Cheap and easy.

 

[DaddyO]

I wish Broaddict would come up with an updated design which is 1 to 1.5in shorter to allow compatibility with existing tail gate tables. I would buy one immediately, but can't justify losing my existing table ($250) then spending to $$$ buy this version and another tail gate table. Odd that they didn't consider this during the initial design. There are likely others similar to me.

As a matter of fact if you search here you’ll find that when they were discussing it there were some of us that pleaded with them to make it usable with their previous tailgate table (that I own). I feel the same way I don’t want to pay to replace it with one that fits the new table just to be able to buy the table. Maybe someone else ll come out with one that fits.

Sponsored