Bronco Team 2 door.

[HeliPilot]

Today’s addition was hanging a Lange ceiling hoist. Now my top top removal to rolling out the door is less than 10 min.

Sponsored

 

[FTXBronco]

Added her to the garage last week...

 

[mlcinema]

Today’s addition was hanging a Lange ceiling hoist. Now my top top removal to rolling out the door is less than 10 min.

How was the install process? What if your not the best handyman?

 

[Cat]

How was the install process? What if your not the best handyman?

I installed mine...no handyman needed! <grin>

 

[Cat]

I just don’t think there’s a better looking vehicle with the top off than the 2Dr Bronco

I agree!

 

[HeliPilot]

How was the install process? What if your not the best handyman?

Wasn't difficult. Instructions are pretty clear on how to mount to wall or ceiling, and proper spacing on the pulleys. Will need a stud finder if garage walls are drywalled like mine. Now, I just back under the lift, raise the top and drive off.

My install was pretty easy because I have a lifetime of power tools available to use. My top is unbolted in less than 2 minutes.

 

[Fly]

Wasn't difficult. Instructions are pretty clear on how to mount to wall or ceiling, and proper spacing on the pulleys. Will need a stud finder if garage walls are drywalled like mine. Now, I just back under the lift, raise the top and drive off.

My install was pretty easy because I have a lifetime of power tools available to use. My top is unbolted in less than 2 minutes.

When you lift the hardtop as high as possible what is the distance between the hardtop and the ceiling?

 

[HeliPilot]

When you lift the hardtop as high as possible what is the distance between the hardtop and the ceiling?

I'm guessing about 1ft. There are 3 crosby clamps on both cables. I run the top clamp all the way up to the ceiling mounted pulley. Mine are mounted to a 2x6, so 2" drop from the mount. Plus, each pulley is a couple inches long, so now I'm at a 4" drop. Plus the length of the doubled up cable, approx 4". Then there is the lifting frame itself which is another 3 or 4 inches.

 

[mikej]

How are your rock sliders working out? They're the ones from Metaltech, right?

Good eye! They are indeed Metaltech. So far so good I’d say. We haven’t really tested them, but they haven’t budged in the slightest since our install. They work great as steps and the blend well, looking like they came with the Bronco.

 

[Webbie44]

It arrived 04/13/23…..did some mods (that I accrued during the 2+ years wait)

 

[mlcinema]

Wasn't difficult. Instructions are pretty clear on how to mount to wall or ceiling, and proper spacing on the pulleys. Will need a stud finder if garage walls are drywalled like mine. Now, I just back under the lift, raise the top and drive off.

My install was pretty easy because I have a lifetime of power tools available to use. My top is unbolted in less than 2 minutes.

Great!

 

[HeliPilot]

It arrived 04/13/23…..did some mods (that I accrued during the 2+ years wait)

AR Badge looks great

 

[Webbie44]

AR Badge looks great

Thanks. AR does make some great stuff, I have the console badge and the slap as well!

 

[climb2descend]

Just completed Mojave Road this past weekend, the Bronco slayed, great vehicle at high speed.

 

[Bikeric]

Had a great time in Moab last week. So many trails.

Sponsored