That relocation bracket is a really easy install.... 3 bolts total I think.... and so easy to get to... goes on the passenger side of that track bar. about $100 or so and it really helps. When you go to bolt the pan hard back up all you have to do is jack up the drivers side (on the frame not the axle) and jack until the holes line up.... Put the bolt in and tighten.Next time around
also gonna post my old yellow grab handles later if anyone wants them
I just found out on BN its a bracket, thought it was a different brand panhard bar, my bad
right side (passenger) of my pan hard.... Just raises the connection point... about 2.5 inches... does not seem like it would do much but it really does. see how flat my bar is? It does make bump steer minimal.
definitely ordering soon, appreciate you pointing it out!right side (passenger) of my pan hard.... Just raises the connection point... about 2.5 inches... does not seem like it would do much but it really does. see how flat my bar is? It does make bump steer minimal.
Switching the Badlands handles out was one of my best mods. What a marketing BS color choice.Next time around
also gonna post my old yellow grab handles later if anyone wants them
Where at? Im definitely going Rojo here
I don't think they're offered like the grab handles are, but here's one I had saved:
It fixed my bump steer.right side (passenger) of my pan hard.... Just raises the connection point... about 2.5 inches... does not seem like it would do much but it really does. see how flat my bar is? It does make bump steer minimal.
Ordering it and go rhinos soon
Btw, how diy is it? Could I work on it in my driveway or do I need a lift and a 6 pack?
I did it in on the ground. You only need a jack to help shift the axle.
gotcha. If I cant get my friend to help, then jack the rear or?
Yup jack the driver's side rear of the frame IIRC.
