Bronco Tuffy storage installed

[Jon_chimpo]

Hey,

just got done with enhancements for the cargo storage. This is how it should have come.
Installed before/after

Sponsored

 

[‘21OBX]

I topped my storage drawer with a rubbery material I found at hobby lobby to keep stuff from sliding around. Def they could have done better. I kept my tie downs exposed though I use them too often to hide.

 

[Jon_chimpo]

How about that dog S, cheap hardware… I originally put them on, but I’ll probably never use them. I can always install later if needed.

 

[mini4mw]

What type of piece did you cover up the body color with at the rear attach locations? Can't believe they just let that stick out like a sore thumb.

Looks great.

Do you get any rattles from it while driving?

 

[‘21OBX]

How about that dog S, cheap hardware… I originally put them on, but I’ll probably never use them. I can always install later if needed.

My wonderful dealer stripped every nutzert putting the tie downs on the drawer. Could take them off if I wanted to. They have held anything and everything I’ve hooked to them no problems.

 

[JediMcMuffin]

What thickness Plywood? 1/2” is my guess

 

[Jon_chimpo]

My wonderful dealer stripped every nutzert putting the tie downs on the drawer. Could take them off if I wanted to. They have held anything and everything I’ve hooked to them no problems.

not going to lie. I cross threaded/snapped 2 studs… and also stripped a tie down point. I’m not making excuses, that hardware sucks! It seemed to go on fine, then bound up. I was lucky, Tuffy mistakenly added to sets of hardware bags in my order. Advice for anyone installing, tap and chase all of those threads before install!

 

[Jon_chimpo]

What thickness Plywood? 1/2” is my guess

Plywood? No ply wood used, just exterior carpeting.

 

[Jon_chimpo]

What type of piece did you cover up the body color with at the rear attach locations? Can't believe they just let that stick out like a sore thumb.

Looks great.

Do you get any rattles from it while driving?

I used carpet squared to cover the bad tooth… yeah it seems like a big over site. It looked unfinished with the body panel showing.
No rattling, it’s solid. I did use blue loktite when installing.

Sponsored