- Thread starter
- #16
Great job! looks fantastic. Wondering if you would share link for struts/latches and if you remember the cut out measurements for the rear latch on the platform. Thanks!!!
The cut out measurements are right around 7/8" x 3.25". Keep in mind there's also a bit of carpet folded in between the latches and the lid!
Nope, not yet! I've looked around online but haven't found anything yet and may lean towards the DIY route.Have you found suitable bins yet? Even if you had to build shallow boxes, without all the drawer hardware it'd be possible to open the lid to access contents; simply pulling them out and placing them on the ground if it all goes bad, and you need the jack.
Post some pics if you get a chance!I used aluminum rails with full extension sliders mount to give a nice pull out tray
Sponsored