having both of them, and having removed and readded them a couple times my best suggestion for the diff drop is to mount the passenger side first then things are better aligned. As for the sway bar relocation kit, I didn't have any issues with it other than my skid plates needing a spacer to clear it
I am still playing with this, one one good video I have seen showed a smaller bracket that goes on the rear up near the pivot point that I don't have which would explain the two gold bolts I have left over as I did finally get everything in but it still doesn't look right but now seeing that ? then tonight I went a different route to break my mind and tried the sway bar disconnect and I did it the way the directions way and the bolts don't line up, its like the instructions asked me to put the flat bolt holes towards the front and I put the flush mount bolts in on both sides and raised the sway bar up and not the other bolt holes don't line up so I don't know if I need to turn it around or what .. nothing dobinson is going on correctly
dobinson diff drop doesn't have a bracket for the pivot point, perhaps you are looking at https://www.brokeninnovation.com/broncoproducts/p/complete-assembly
