DIY - ARB Twin Compressor Install using KR Off-Road Engine Bay Mount

[ICUGAZN]

Did you ever make a video of this installation? I understand the concept but would love to see it done and follow along.

This should help.

Sponsored

 

[4x4TruckLEDs.com]

Did you ever make a video of this installation? I understand the concept but would love to see it done and follow along.

There are a few videos out there

 

[RagnarKon]

Did you ever make a video of this installation? I understand the concept but would love to see it done and follow along.

Still waiting for my Bronco.

As @4x4TruckLEDs.com posted... a few people have made videos on it already—and some of them are really good.

Assuming I get my Bronco before the end of time... I'll probably still do a written guide for those of us who prefer following printed instructions rather than trying to following along on a video.

 

[omg_bbq]

Still waiting for my Bronco.

As @4x4TruckLEDs.com posted... a few people have made videos on it already—and some of them are really good.

Assuming I get my Bronco before the end of time... I'll probably still do a written guide for those of us who prefer following printed instructions rather than trying to following along on a video.

Stay strong, you’ll get it. I got mine a month ago after reserving the morning of day 2.

 

[omg_bbq]

There are a few videos out there

Much appreciated

 

[ODG.Brad]

Anyone know the part number for the hitch 4/7-pin plate?

I am fabricating a bracket for remote air, moving the ARB air coupler to the rear of the vehicle using the 4/7-pin plate near the hitch, but I need a picture/measurements of the bracket or link to buy the bracket. I have the 4-pin bracket and have designed up a way to move the 4-pin over and add the hole for the air coupler.

 

[Velocity00]

We installed our ARB Twin Compressor over the weekend using the KR Off-Road Engine Bay Mount. The install was very simple after figuring out how and where to tap into an ignition source.

Now we need an excuse to air down the tires!

Once you wired into the fuse box, how did you get the fuse box cover back on? Did you have to drill a hole for the cable to pass through?

Sponsored