Injen Charge Pipes installed on 2.7 with Injen CAI

[TireFlate]

Do you have any images showing where you drilled the holes?

Thanks

This is all I have. I did not take a photo before installation.

Sponsored

 

[Doubleajaybrock]

Are they parallel with the existing holes or did the mounting height change with these new holes?

Thanks man

This is all I have. I did not take a photo before installation.

 

[TireFlate]

Are they parallel with the existing holes or did the mounting height change with these new holes?

Thanks man

The top hole is for the ground and oval shaped. I went straight over from that hole and measured for the bottom hole. I installed the ground wire in its original hole, not in the bracket.

 

[Doubleajaybrock]

Did relocating the holes effect the support beams bolting up?

The top hole is for the ground and oval shaped. I went straight over from that hole and measured for the bottom hole. I installed the ground wire in its original hole, not in the bracket.

 

[TireFlate]

Did relocating the holes effect the support beams bolting up?

I did have to do some minor adjustments, but no other modifications. I did not use the base angle support bracket, but it is very solid even without it.

Sponsored