- Thread starter
- #1
Hi Friends - recently changed out my rear bumper, and am now receiving a park aid fault on the display behind the steering wheel and the error message attached. Any ideas and troubleshooting suggestions?
Sponsored
I did. Seem to all be installed correctly.Did you hook the harness back up? Mine did that when I forgot to reconnect the harness on the 3rd time I took my bumper off.
Hi there, I'd be happy to look into your Bronco concerns on my end. Will you send us a message with your VIN and dealership info? I can look into things on my end.Hi Friends - recently changed out my rear bumper, and am now receiving a park aid fault on the display behind the steering wheel and the error message attached. Any ideas and troubleshooting suggestions?
I have the same issue. The problem with mine is the oseal in the wiring harness is stretched out, so it's not letting it fully connect.Hi Friends - recently changed out my rear bumper, and am now receiving a park aid fault on the display behind the steering wheel and the error message attached. Any ideas and troubleshooting suggestions?
Big DUH moment. Plugged the license plate plug into the sensor. Why would Ford make the light connection and sensor connection the same!?! . Resolved. Thanks for all the tips!Hi Friends - recently changed out my rear bumper, and am now receiving a park aid fault on the display behind the steering wheel and the error message attached. Any ideas and troubleshooting suggestions?
I just ran into this problem today. I put on a hitch receiver, now I noticed after clipping the two connections parking aid failure happens. Has anyone else had an issue like this? One thing I noticed is that the connectors don't snap back in. I've inspected the connectors. Can't see anything, but it is clear it's not fully seated