Are those the DeeZee mud flaps?Skate board grip tape with clear wrap on the door sills.
and advance auto parts mud flaps.
![]()
![]()
Sponsored
Are those the DeeZee mud flaps?Skate board grip tape with clear wrap on the door sills.
and advance auto parts mud flaps.
![]()
![]()
that's GREAT .... was installation and wiring easy?Underhood light
![]()
Is yours Sasquatch or no? Those mud flaps look nice. Still looking for some for our Sasquatch.Skate board grip tape with clear wrap on the door sills.
and advance auto parts mud flaps.
![]()
![]()
Very easy, I routed the wires under the hood insulation to a hole on the drivers side, then back toward the battery. You have to drill a hole for the plunger to go into, but that was very easy. I think it took me about 15-20 minutes, once I figured out where I was routing the wires.that's GREAT .... was installation and wiring easy?
from Amazon? link?Very easy, I routed the wires under the hood insulation to a hole on the drivers side, then back toward the battery. You have to drill a hole for the plunger to go into, but that was very easy. I think it took me about 15-20 minutes, once I figured out where I was routing the wires.
Honestly, that looks more like a Bronco Sport! Mounting it on a Bronco will be different.Is yours Sasquatch or no? Those mud flaps look nice. Still looking for some for our Sasquatch.
Non SasquatchIs yours Sasquatch or no? Those mud flaps look nice. Still looking for some for our Sasquatch.
Not sure what DeeZee is. But they are the generic truck flaps at advanced autoAre those the DeeZee mud flaps?
It is on a bronco… also way cheaper than anything that’s offered if you don’t mind spending an hour or two for prep, trim and mounting.Honestly, that looks more like a Bronco Sport! Mounting it on a Bronco will be different.
I am using that and it works well. You don’t have to run wires up from the ports under the radio.I'm tempted to do this too. I could route the cord along the mount and have nothing laying on the dash.
Any pics?Cerakote Trim Coat (10 pack of pre-moistened wipes). I used 8 for all of the Sasquatch fender flares. and it was a pretty thorough coating. I may do some touch up after I see how they get dirty.
Washed them all with a soft scrubber pad and Dawn blue soap, let them thoroughly dry, put them in my basement to control temp and dust, and then applied the Cerakote. Waited 3 hours, put them back on.
Now my handles and bumper look like trash.
How close is their orange to oem trim color? I have a badlands and wanted to do the same but wasn’t sure how it would match. Pics look good!I underestimated how much better my interior turned out with these stickers from stickerfab
![]()
![]()